0 Results: New & Used in Engine, Engine Parts & Transmission in Bakewell 0832, NT

Nissan patrol alternator to suit 2011 ZD30 engine, perfect condition 120,000 klm

Complete. Will mail at buyers cost. As is where is.

Holden Commodore VE 2007 V8 L98 starter motor. Bench tested and load tested. Works fine. Removed from working car due to exhaust upgrade. Will post at buyers expense. Between $15 / $30 within Australia only. No heat shield or retaining threadsi ncluded. No bolts from starter to block included. Starter motor only. Genuine part # M000T35573 Or part # ****2964 compatible. As is where is. First in best dressed. Cash o lying transactions No Gmail tossers CHeers for looking Arnold

This engine is from a Mazda 3 and was running when removed from the vehicle that was written off. The engine had done less than 100,000 Klm. Long motor with starter and Alternator. As is where is. Will help with the loading of the engine. Call Lorrence at Berrimah Automotive during business hours only. .

Complete engine (Long Motor) removed from write off. Was running before removal. Under 100,000klm on clock. Comes with gear box and starter motor / Alternator and some othe accessories. As is where is. Will assist in the loading of the engine. Call Berrimah Automotive and ask for Lorrence. . During business hours only.

Holden Commodore VE 2007 L98 V8 Heater Hoses. Complete with clamps. Removed from a working car. No leaks and still in perfect working condition. Been off the car for less than two weeks and stored out of the sun and hung up clean and dry. Seals are hard if not impossible to find so this would be the perfect replacement if your seals have failed and are leaking. Will post at your expense anywhere within Oz.

Holden Commodore VS ECU module. Original part Out of a running car. (Auto) As is where is.

This gearbox is a three speed including bell housing and shifter. As is where is. Will include delivery if in my area. Was removed from a Holden ute.

Selling my 4.0L V6 1GR-FE XEDE PROCESSOR Can post interstate. RRP: >$900 http://www.chiptorque.com.au/xede-processor/ Perfect for towing heavy loads and overall improvement in fuel economy. Came out of my GXL Prado due to selling the vehicle, this processor allows the user to optimise/tune your vehicle in comparison to other tuning modules with minimal capabilities. The module needs to be wired in as a piggyback and tuned by a trusted tuner. Wiring diagram available. Dual map availabl

Smiths BP2404-00C - Oil pressure gauge 0-100 psi This Sender Unit Part Smiths PT1811-10 Don't think has been used PTR1811-10 Having a resister. Please read this that I found on the web making sure you can use it. The PTR1811-10 Sender Unit costs between $150 and $175 Smiths BP2404-00C - Oil pressure gauge 0-100 psi The original design had the oil pressure gauge/sender powered from the “B” connection because back then the oil pressure senders were voltage independent bi-metallic switching types.