11 Results: New & Used in Auto Body parts in Browns Plains 4118, QLD

New, but obviously has sat for a long period of time so no shiny packaging. Free barn dust though. I could not find a model figment but did find a UK seller listing the same part for $260

Very large single cab alloy ute tray tailgate loader traffic control body. The tray was made by Trans Alloy in Sydney as a setup for a traffic control ute. See my other listing for the actual traffic control module. Has a fully functioning Lyco 300kg tailgate loader. This is overall 2900mm long from back of loader to headboard front and 1900mm wide sides are 300mm high. It has the chassis mounting cross members included and has a round bar headboard with a full width alloy mesh rear window guar

Steel canopy tool box tradie cover for tray back ute. This is 2140mm long, 1800mm wide and 820mm high. It sits on the flat tray of the ute and is bolted down in each corner. It has lift up sides with locking pins on each side, not gas lift struts. The sides are heavy and solid. Has side over centre latches on each corner and two keyed alike locks with keys. Can store ladders etc on top with tie down rails on top. Could do with a paint. I can load it onto a ute or trailer at this end. Pick up is

Alloy ute tray rear steel ladder rack with slip in/out mounts. Comes with mounts. It is exactly 1785mm outside of mount brackets and is 810mm top of bar from tray floor. Made for MMM trays but suits all alloy trays. It is in good condition but could probably do with a clean. Pick up is from Heritage Park on Brisbane south side near Browns Plains. If you are reading this it is still available. I will remove it immediately it is sold.

Space extra cab alloy ute tray back. This tray was made by MMM trays and is overall 2050mm long and 1850mm wide with 250mm high sides. It comes with a good set of LED lights including number plate light and bracket and the lights have steel protectors fitted. It has two chassis mounting members included as well as the mounting bolts and washers and fuel filler connection and could be easily adjusted to any chassis. The mudguards are included. It has arear window protector fitted and ladder pins

Single cab alloy ute tray with under body tool boxes. This is overall 2500mm long and 1850mm wide with sides 250mm high. It has the good quality mud guards and mud flaps and comes with a set of lights including number plate light and bracket as well as mounting bolts. It has the chassis mounting cross members included as well and while it came off a Triton it is multi adjustable can be easily adjusted to any chassis. It has the tie down clips around the base and comes with a canopy/tarp bow. It

Hamer king series bullbar to suit 2021 dmax Originally purchased in October 2022 All parts included Pick up in Brisbane only

Wide high single cab alloy ute hydraulic tipping tray. This is overall 2450mm long and 2030mm wide and sides are 330mm high. This makes it extra wide and high for tipping larger loads. The tipping mechanism is by Australian Tipping Systems and is a twin ram model. It is fully functional and comes with raise/lower switch and long battery leads. It came off a BT50 but can easily be adapted to any chassis with a couple of brackets welded to the tipping frame. It has steps on both sides at front an

XR XT Ford Falcon******1969 Profile boot seals - Also available for *****1969 ZA ZB Fairlanes 1966 -1968 US Falcon 2 Door coupes.

Diesel fuel tank brackets and plate