1 Results: New & Used in Engine, Engine Parts & Transmission in Clayton 3168, VIC

Selling Holden HK HT HG Monaro 350 V8 exaust tailpipes tips.In brand new condition never used.Call or sms Jim .Note I don’t respond to emails.Can post at buyers expense.Please look at my ather adds as they may be of interest to you.

Selling Holden HK HT HG Monaro, Premier,Kingswood New Old Stock Gear Leaver Lock.This is to suit Opel 4speed floor shift.IIt is brand new in original box complete and also comes with reproduction NASCO accessories book dated Dec1970 which shows all the accessories you could order on your Holden.Gear Leaver lock part no:2812594 this is New Old Stock and very rare.Please call or sms Jim .Note I don’t respond to emails.Can post at buyers expense.Please look at my ather adds as they may

Bought brand new and used for a few months in my car before I had to change the setup. Superduty .080" wall section pushrods, will suit a standard length Holden 253-308 application. These retail for about $220; I'm losing money as I had to go and buy another set, but make me an offer if you don't like the asking price. Can post easily.

Used for a dyno run-in and about 40km of road driving on a Holden V8 stroker. Actually had the heads machined enough to put the valve geometry out, so needed a different length. Perfect condition. When new they cost about $170.

Good used condition, dark grey coating looks pretty awesome and only has minor scratches, male 13/16" filter thread, male AN10 fittings, ready for hoses.

Set of new NGK U4031 Evo IV Coils Left over spares from race car. Worth $169 each.

2.4L INTERCOOLED WHIPPLE VALLEY KIT – BY YELLATERRA Suits Chrysler Jeep or 300C with Hemi V8 5.7 / 6.1L Engines Unique chance to purchase this complete Whipple 2.4L twin-screw, dual intercooled engine valley assembly and drive. Ideal for your everyday factory Hemi V8 vehicle or that Hemi Create Engine Transplant you have planned for your project car. Was run on a 6.1L 300C SRT for about three years as a daily driver. Kit has been cleaned and re-assembled with new sealant and o-rings -

Ford XR5 3" Stainless Downpipe Decat ONLY Bought brand new from: https://focusonperformance.com.au/3-stainless-downpipe-decat/ Brand new never used Fully hand TIG welded stainless steel pipework and flanges Fits both aftermarket & factory cat back systems Fits Focus XR5 & RS mk2 all year models Twin o2 sensor bungs on downpipe for use with aftermarket AFR gauges. Contact Brian Located Clayton South VIC

Came off a running car, part of a tunnelram setup. Actually have a second (matching) carb if you're after a pair. Could do with a clean up but was functionally fine when removed. Can post.