3 Results: New & Used in Engine, Engine Parts & Transmission in Katanning 6317, WA

Holden red motor 186 202 cylinder heads and cranks. Can be re machined. Can deliver to Perth.

Hello Everybody, I am offering up for sale one rocker gasket to suit either Peugeot or Citroen, not makes of cars I usually deal with, but for anybody who is interested, the part number on the packet will tell the story, will post Australia wide at buyers expense. Best Regards. Jeffery Stewart.

torqstorm centrifical supercharger kit to suit LS2 /3 1000 pound injectors 2 bar map sensor..cromvernadium spark plugs crank pinning kit . Supercharger is in collie wa .

Hj45/47 front and rear axels complete with diffs , drum brakes. Also 4 speed gearbox and rear tailshaft and two rear springs

Full recon 3sfe. I believe suits camry maybe not Rav

I got this programmed and sent from overseas. in the meantime i found a 2nd hand one and installed so this is spare. the LF number needs needs to match suit mazda 3 bl

Front tailshaft/propshaft shaft for a short wheelbase series Land Rover. New quality uni joints and rubber gaiter, greased and ready to go. However splines/slip joint is worn. I don’t run free-wheeling hubs so at high speed it slightly vibrates. If you are running freewheeling hubs, this would be fine off-road at lower speeds on a rough surface. It’s unlikely you could properly balance, but on the highway with the hubs disengaged it wouldn’t be turning anyway. This does still function fine when

auto trans from a 2009 2wd triton was working good smooth and noiseless no leaks good secondhand I believe this can fit the 4wD just have to swap transfere box over For extra $100 will give warrenty

4 speed synchromesh gearbox and transfer case to fit MQ Nissan patrol 4wd

For sale: New Xtreme sprung 4 puck cerametallic clutch plate to suit Ford Escort 1600 Xflow models with the 23 spline gearbox input shaft. Part number shown in pics. $150 includes Australia wide postage.