0 Results: New & Used in Engine, Engine Parts & Transmission in Kendenup 6323, WA

Holden red motor 186 202 cylinder heads and cranks. Can be re machined. Can deliver to Perth.

Front tailshaft/propshaft shaft for a short wheelbase series Land Rover. New quality uni joints and rubber gaiter, greased and ready to go. However splines/slip joint is worn. I don’t run free-wheeling hubs so at high speed it slightly vibrates. If you are running freewheeling hubs, this would be fine off-road at lower speeds on a rough surface. It’s unlikely you could properly balance, but on the highway with the hubs disengaged it wouldn’t be turning anyway. This does still function fine when

For sale: New Xtreme sprung 4 puck cerametallic clutch plate to suit Ford Escort 1600 Xflow models with the 23 spline gearbox input shaft. Part number shown in pics. $150 includes Australia wide postage.

For sale: Cam cover to suit Ford Cortina Escort Sierra with Pinto OHC engine. Later wide lip type from Sierra that seals better. Nice and straight and in VHT engine primer ready for your colour. Comes with new rubber spark plug lead separator. $125, will post.

Honda Civic D16y8 engine and gearbox still runs perfectly still in car to test.

For sale falcon streetstock sealed engine out of el in good cond about to be removed from car comes with all bolt ons asking $3700 video of it running located in albany posted on other pages

Exchange Transmission that has had an A clutch power pack upgrade, new pump gears, and teflon input shaft seals. These were done, but the box wasn't fitted, as the vehicle ended up with a ZF 24 box. 12 months warranty if fitted with reconditioned torque converter by qualified Auto shop or land rover independent. ( proof required) Fitting also available for extra ( includes warranty)

Mercedes M112 engine V6 petrol good running engine out E320 W210 car new seals and gaskets 260000km call for more information

Zd30 di motor and parts for sale. The motor as new piston and rings with new main and conrod bearing. But it have the worry crank the motor is a Zd30 di. But the crank is out of a crd motor went i put it back to together i didn't realise the difference There is a new head never been on a motor as no cams $800 but I used the cams All the other parts are of a Zd30 di motor 2005. The stand will not go with the motor. The new rings and piston and bearing only been turn over by key. I couldn

Great working condition. Purchased new, around 12 months use in vehicle but only removed as it is was too big for our car. Series Model MP-4501 / MP-4550 S/N D-12967 Can post.