66 Results: New & Used in Engine, Engine Parts & Transmission in Moolap 3224, VIC

cps crankshaft position sensor new and never fitted, ordered for a customer but found it was a more obvious problem before even fitting this

From an 86 5.0 part no ******1021

Works well, went with different style

Near new, low km rebuild

Came from a low km rebuild, went fuel injection instead

I have 5 more new glow plugs that I got for my gl320, this should fit alot of the diesel 320 engines like cls320 ml320 and more, then I believe it is the same as jeeps and Chrysler engines too as they shared a few diesels (I believe the 300c) but please do your research. Price is for each one and includes postage

I have a great condition waterpump, came from a 69 mach 1 mustang Please check fitment

Bought from a wreckers with warranty but never ended up using it

This is from a 351c Cleveland in a 1970 mustang. I have confirmed the clutch latches when 12v is applied but I did not have a condenser to test. Spins smoothly. Should fit other vintage Ford's too. And I am only guessing it will fit a Windsor, not sure if it fits the 302 etc. Postage will be $25 extra

These were from a good running engine. Nothing wrong with them and tested before removal. Was from my 2.4 transit.

Have new stock standard size bearings, will fit in any 1grfe motor, still sealed

From a holden/opel astra, always had it spare but the car has since been sold. I verified it worked fine

I have a third gen camaro radiator spare, never used. It's for an auto (although you could just block the auto trans cooler or not connect it to suit manuals). This was for my 87 5.0, but pretty sure they are all the same,. And also fits firebird and trans am tooml. Can give you dimensions.

Have these electric fans from an 87 3rd gen camaro, worked well, comes with the connector pigtails too if needed

Missing one,, from a 2016 vf ii. You can buy single springs online or at local engine builders for $15 or less

Worked well when came off car

Also selling performance ones in my other ad, I labelled these to show which is for the lh computer and which is for the ez computer.

I have these chips which both go in the 2 computers for your 928, easy to install, takes 10 minutes and a screwdriver, no other mods needed, online you can see the power benefits, although it was better documented a few years ago. Something like 18hp gain, but more if you have free flowing mufflers and even more with out catalytic converters. I'm going a custom route so not needed any more

I have a 86 belt tensioner, worked very well but I'm going for a fixed system for a race modified 928. I didn't have a tensioner light on or anything so it did a good job. The shell of this alone fetches $450 alone, Ideal for someone wanting an original system or had a failure with there old one

70,000kms on it. Work well

Has a sensor on it too. Will fit either model

Came off a low km territory, same and land rover too

Came off a 2015 captiva, these can fail and keep your fans on, make them stay off, or all sorts of other problems

Have the biggest alternator available for a Mercedes, 180a ,think this can be retrofitted onto alot of other mercs and is a common mod to charge the car faster and for bigger sound systems. This came off an sl55, and will fit the above, has cracking around the back plastic, but the clip still clips in, was a tight fit and someone knocked it removing it. Have video of me testing it on the bench hooked up to a battery, charging at 14.1v. So verified it working, it's just at a reduced price due to