3 Results: New & Used in Trucks in Mount Gravatt 4122, QLD

• 560000 km
• 23000 kg(GVM)

2005 Fuso Fm Series 12 pallets 12 Tonne Hanging Gates 3 Tonne tailgate Manual eatons gearbox New front tyres 560000 on odometer Hanging gates New brakes Asking price $33000 Msg or Call

Side Marker Lights, Magnetic, Fit and remove in seconds , Temporarily fit Operated Marker Lights. Oversize, Truck Over Dimension Clearance Light, Amber - Red, Amber and Red , Battery Operated, lit ,On/Off Led Switch, Magnetic Mount Used for Oversize Loads ETC, Don't be fined by the Road Authorities. It will cost you around $1000.00 Plus . No Wires or Snags. This item is battery operated with an On/Off lit Led switch and is Magnetic mounted to your load. Clearance Light is ADR Approved Light Set

Perkins diesel rocker arm shaft assembly 4-107 / 4108 engine Came off a 4-107 Good condition. Can post anytime at your expense.

Perkins 4108/07 tappet cover with oil cap and breather. Came off a Marine engine. Good condition Can deliver at your expenditure.

• 520 hp
• 1313528 km
• 70 kg(GVM)

Hi Volvo Fh 520 Prime Mover 2009 Up for sale Run perfectly Recently done year inspections Can introduce to work if Interested with Truck

Currently have 2 x N14E Cummins blocks for sale. They have been machined, tunnel & faced, STD LPF for both, reports on request. No cam bearings fitted. These are Remanufactured bare blocks only.

Currently have a standard / standard 12v92 crankshaft for sale. The crank has been checked, tested and polished by a local engineering shop. Report available on request. The crankshaft will be sold with genuine mains, bigends and thrust washers. The crankshaft is currently split and can be sold in halves if required. Location is Salisbury, Brisbane.

I have a running take out QSM11 Cummins industrial engine for sale. This engine has had a bearing roll, front & rear seal's replaced, full service and valve set. The engine has been dyno tuned and full report is available with the engine. It performed as per factory specification, 400HP @ 2100RPM. It is sold as an outright buy. This engine is also subject to GST when sold.

This is a FD/FG hino drivers seat without suspension in goodbcondition location Salisbury Brisbane

I have a remanufactured Cummins 6CT/CTA block available. We have had top deck machined, counter bores, main tunnel etc all been done. Block will come with report from engineering shop, this block is ready for final clean and ready to use. I can ship anywhere in Australia via TNT for a cost. Rebuild kits are also available. The ESN on the block is hard to read, but option tag was*****4107 and CPL was 1845. Some parts are available as well. Price is subject to GST when sold.