ADVERTISEMENT
Sort

Filter & Refine

  • ford falcon
View Layout
ford falconNorth NarrabeenClear all

Sorry, we didn't find any results in your area but did find 27 ads in surrounding suburbs.

Click here to see all results

Ford Falcon fairlane workshop manual

EL Falcon fairlane repair service manual brand new

$25
Warriewood, NSW

20/01/2021

GENUINE FORD XR - XY TRICO FRONT WINDSCREEN WIPER ARMS AND BLADES

What you are buying here is a pair of original Australian made, TRICO wiper arms to suit Ford XR-XY Falcons as well as other Fords (F100’s etc) One of the spring loaded clips for the wiper blade holder (see photo) has a small crack in it, so would need replacing or fixing, although the arm still holds in OK, it’s just a loose fitting. Main springs are a bit rusty (see photo) as normal, but work fine and the 2 mounting hubs seems to be a slightly different grey colour (see photo) but overall t

$30
Terrey Hills, NSW

22/09/2023

GENUINE FORD 1967 XR FALCON INSIDE REAR VIEW MIRROR

What you are buying here is a genuine rear-view mirror that came out of a 1967 Ford XR Falcon 500. The frame, mount bracket and mirror glass are all still in very good original condition for its age. There is the tinniest mark on the glass (see last photo) but this is not noticeable when mounted in the car and could possibly be polished out. (Only removed due to replacing it with a repro chrome version) I have other XR Falcon parts for sale for combined postage if required. POSTAGE IS $

$90
Terrey Hills, NSW

22/09/2023

FORD GEAR SHIFT BOOT KIT - SUIT FORD XR XT XW XY XA AND EARLY XB (NEW)

What you are buying here is a RARE SPARES (Part# F2087) gear shift boot kit to suit Ford XR-EARLY XB with manual floor shift. These currently retail for around $55, but I bought this for my XR Falcon restoration, that has a Borg warner single rail gearbox and not a toploader or similar. It wasn’t till later that I realised I needed to use a different boot kit as the single rail gear stick comes out at more of an angle, rather than strait up and down. This is still new in the packet and will

$15
Terrey Hills, NSW

28/07/2023

BORG WARNER SINGLE RAIL GEAR STICK RUBBER BOOT (FORD)

What you are buying here is a rubber gear stick boot that was on a Borg Warner Single Rail gearbox that came out of a FORD XE Falcon (so I was told, but could be from something else). The gearbox went into an XR V8 Falcon and the boot was not used. It has a small tear in the rubber (see photo) but apart from that it appears to be pretty good condition for its age. POSTAGE IS $10 AUSTRALIA WIDE

$10
Terrey Hills, NSW

28/07/2023

Head light lense Ford Falcon XF right

Head light lense Ford Falcon XF right Pick up prefered If the ad is up then they area available

$10
Terrey Hills, NSW

11/03/2024

Head light lense Ford Falcon XF left

Head light lense Ford Falcon XF left Pick up prefered If the ad is up then they area available

$10
Terrey Hills, NSW

11/03/2024

Weather wind sheild drivers side window XF Falcon

Weather or wind sheild for the drivers side window Currently on an XF Falcon Is Ford branded It is attached around the top and side with a double sided tape and has two fittings on the bottom edge Note that it has a crack near where the door mirror is Pick up prefered If the ad is up then they area available

$50
Terrey Hills, NSW

11/03/2024

Windscreen sun visior from an XF Ford Falcon

Windscreen sun visior from an XF Ford Falcon Originally from an XF ambulance It is built with a top and bottom layer of steel to create the form. There is some rust which should be clear in the photos Pick up prefered If the ad is up then they area available

$300
Terrey Hills, NSW

11/03/2024

FORD FALCON XR XT XW XY GS GTHO CONCOURS PLASTIC FRONT SPOILER

What you are buying here is the standard repro/concours (2 x piece) plastic front spoiler, originally for the Ford XW-XY, but will also fit the Ford XR-XT. This came with the 1967 Ford XR project car I bought. It was new and assembled, but never fitted to the car. I didn’t want a front spoiler on an XR so I’m moving it on. As it was assembled using the adhesive backing for the centre support, I won’t be pulling it apart so it’s pick up only. It doesn’t have the 2 small chassis mounting brackets

$90
Terrey Hills, NSW

20/02/2024

Click here to see all results
Save search and get notified when new items are posted