0 Results: New & Used in Trucks in Adelaide River 0822, NT

• 12000 km
• 4495 kg(GVM)

Hino 616 AT 3430 Wide Trade Ace 6 Speed Auto 4,495kg GVM - normal car licence - 12,000km - Spotlights - UHF and Antenna - Cel-Fi and Antenna - Dash Camera - Beacon - Tinted windows - Custom alloy canopy - Lithium Battery with DC Charger, Inverter, Battery monitor, x2 Solar Panels - Canopy Lighting - Water tank / pump - Compressor - Hose Reels - Fridge Slide Vehicle built for Auto Electrical / Mechanical Field Service. All fit out done in house. Genuine reason for sale - no longer required.

Clutch to suit scania 3 series , pull type 430mm New clutch never used cost $2400 new, make an offer!

• 23456 km

Load net for trailer or roof rack, (formerly air cargo). Very strong thick straps, 30 secure spring hooks. About 3 x 2.5 metres. 2 available, $200 each.

• 296442 km
• 4x2
• 6500 kg(GVM)

NPR 300 Isuzu Truck in good running order, green slip to 21 June , registered for 1 month , hydraulic lift on the back, needs new tyre on the spare ,runs well and has no issues.Has a ding in the passenger side door

4300 X 1400 HERCULES ALLOY BODY AND HOIST ON SUBFRAME READY TO WORK

Description CAV 24 volt alternator regulator Type 440 Land Rover Series 2A and 3 Fitted to other vehicle types This was fitted to an Albion bus Removed when the vehicle was only about two year old and had low mileage

As New Leyland 401/410 Engine Cooling fan. Fan is steel. Removed off the engine when less than one year old. Mint condition

VERRY TIDY 4300 X 1400 HERCULES ALLOY BODY AND HOIST ON SUBFRAME READY TO WORK

Purchased recently as a spare for our Mack Metro liner but have since sold the truck & am clearing out surplus parts. Caliper Assembly is brand new & available to be sent anywhere in Australia. Brake Assembly comes with pads springs. Big reduction on new price. $3200 + GST Please contact me if you require further info or pics

Save $$$ on your fuel costs and increase Power using the #hydrogenfuelsystems Welded Steel enclosure boxes – and welded Mild steel enclosure boxes suitable for use as hydrogenfuelsystems enclosures or #hydrogen kits. call completre hydrogenfuelsystrems systems are always available This is a fully Welded , Lockable , powdercoated steel Box shown with Hydrogen fuel system mounted and measures 430mm x 300 mm x 350 mm high . Box is airtight and made of 1.2 mm steel with a key lockable t