62 views
Manley Jumbo Shrimp Tube Preamplifier (remote volume)
$2,500 Negotiable
Beautiful preamplifier, one of the most well rounded ones I have owned. Has a radio fequency remote volume control that does not require line of sight to work.
Short signal paths, and great tube sound and low output impedance (50 ohms) makes it compatible with most power amplifiers.
Locally purchased/ Australian unit. Current RRP $5495.
In as new condition
Extremely well reviewed
http://www.6moons.com/audioreviews/manley6/jumboshrimp.html
http://www.enjoythemusic.com/magazine/equipment/1002/manleyshrimp.htm
Official technical specifications
ALL-TUBE: Vacuum Tube all-triode design
Input Tubes: 2x12AT7EH large plate Electro-Harmonix Russian
Interstage Follower Tubes: 2x5670 GE USA dual triodes
Output Tubes: 2x7044 or 5687 GE JAN NOS
Five Line Level Inputs: unbalanced RCA
MUTE switch and Warm-Up muting delay
ALPS motorised volume control: Accurate tracking usually within 0.5dB. Smooth operation. (no detents)
ALPS balance control: Center detented
Record Output: (AKA “TAPE OUT”) Unbalanced RCA jacks, unbuffered, passive (always ON)
Main Outputs: Two sets of unbalanced RCA main outs for bi-amping or driving a powered subwoofer
Gain: 11.8dB
Input Impedance: 250kOhm
Input Sensitivity: 200mV in yields 1V out
Maximum Input Level: 5V in produces 1.5% THD at output
Frequency Response: 10Hz - 80KHz; 20Hz - 20KHz, -0.3dB
Noise Floor: Typically -83 dB 20-20K with volume control fully open
Noise Floor: Typically -95 dB A WGT 20-20K with volume control fully open
Noise Floor (shorted input): Typically -94dB 20-20K with volume control fully closed
Noise Floor (shorted input): Typically -106dB A WGT 20-20K with volume control fully closed
S/N Ratio: typically 95dB A WGT 20-20K
THD: 0.02% at 1Vrms output
Output Impedance: 50ohms
Maximum Output: 23dBu @ 1.5% THD into 100K load (10.9Vrms)
Maximum Output: 20dBm @ 1.5% THD into 600ohm load
Badge Lamp: LED illumination
RF Remove Control: commands volume control UP/DOWN; uses 9V battery
Power Consumption: 55 Watts (485mA @ 120VAC)
Operating Mains Voltage: Units are purpose built for original destination country’s mains voltage: 100V, 120V, or 220-240VAC as indicated on the serial number badge. Power transformer must be replaced in order to change mains operating voltage. 120VAC units may NOT be rewired to put the primaries of the power transformer in series for 220-240V operation or a large radiated field of hum will develop. If changing locations/voltages, the power transformer must be replaced with the dedicated one for the voltage at which it will operate.
Mains Voltage Frequency: 50 ~ 60Hz
Dimensions: W=19”, L=11”, H=3 1/2”
Shipping Weight: 15 Lbs
6moons review here. "Because the Jumbo Shrimp does everything right, it will prove itself with transistor and tube electronics."
Features:
Very short, simple minimalist signal path. All-tube design. 2 x 12AT7 input, 2 x 5670 driver, and 2 x 7044 output.
Signal path furnishes very high dynamic range with prodigious input and output signal headroom.
Signal path also delivers high bandwidth, low noise, modest local negative feedback and low distortion, and is voiced for best musical performance.
Radio-Frequency based remote command of the silicon-free high-quality motorised volume attenuator set, for infinitely resolvable control of listening levels. No need to "point" the remote in any direction. Now the Shrimp's attenuator set can be controlled from another nearby room, through walls, floors and doors, and through opaque equipment closet or cabinet doors too!
Dedicated White Follower stage using the 5670 dual triodes effortlessly drives all passive interstage circuits; volume, balance and output stages receive crisp instruction from the Follower regardless of control settings.
Generous energy storage via large power supply capacitors for more impact in the bass.
No global feedback makes the Shrimp very fast sounding.
Also can safely packing and shipping around Australia by buyer cost.
Short signal paths, and great tube sound and low output impedance (50 ohms) makes it compatible with most power amplifiers.
Locally purchased/ Australian unit. Current RRP $5495.
In as new condition
Extremely well reviewed
http://www.6moons.com/audioreviews/manley6/jumboshrimp.html
http://www.enjoythemusic.com/magazine/equipment/1002/manleyshrimp.htm
Official technical specifications
ALL-TUBE: Vacuum Tube all-triode design
Input Tubes: 2x12AT7EH large plate Electro-Harmonix Russian
Interstage Follower Tubes: 2x5670 GE USA dual triodes
Output Tubes: 2x7044 or 5687 GE JAN NOS
Five Line Level Inputs: unbalanced RCA
MUTE switch and Warm-Up muting delay
ALPS motorised volume control: Accurate tracking usually within 0.5dB. Smooth operation. (no detents)
ALPS balance control: Center detented
Record Output: (AKA “TAPE OUT”) Unbalanced RCA jacks, unbuffered, passive (always ON)
Main Outputs: Two sets of unbalanced RCA main outs for bi-amping or driving a powered subwoofer
Gain: 11.8dB
Input Impedance: 250kOhm
Input Sensitivity: 200mV in yields 1V out
Maximum Input Level: 5V in produces 1.5% THD at output
Frequency Response: 10Hz - 80KHz; 20Hz - 20KHz, -0.3dB
Noise Floor: Typically -83 dB 20-20K with volume control fully open
Noise Floor: Typically -95 dB A WGT 20-20K with volume control fully open
Noise Floor (shorted input): Typically -94dB 20-20K with volume control fully closed
Noise Floor (shorted input): Typically -106dB A WGT 20-20K with volume control fully closed
S/N Ratio: typically 95dB A WGT 20-20K
THD: 0.02% at 1Vrms output
Output Impedance: 50ohms
Maximum Output: 23dBu @ 1.5% THD into 100K load (10.9Vrms)
Maximum Output: 20dBm @ 1.5% THD into 600ohm load
Badge Lamp: LED illumination
RF Remove Control: commands volume control UP/DOWN; uses 9V battery
Power Consumption: 55 Watts (485mA @ 120VAC)
Operating Mains Voltage: Units are purpose built for original destination country’s mains voltage: 100V, 120V, or 220-240VAC as indicated on the serial number badge. Power transformer must be replaced in order to change mains operating voltage. 120VAC units may NOT be rewired to put the primaries of the power transformer in series for 220-240V operation or a large radiated field of hum will develop. If changing locations/voltages, the power transformer must be replaced with the dedicated one for the voltage at which it will operate.
Mains Voltage Frequency: 50 ~ 60Hz
Dimensions: W=19”, L=11”, H=3 1/2”
Shipping Weight: 15 Lbs
6moons review here. "Because the Jumbo Shrimp does everything right, it will prove itself with transistor and tube electronics."
Features:
Very short, simple minimalist signal path. All-tube design. 2 x 12AT7 input, 2 x 5670 driver, and 2 x 7044 output.
Signal path furnishes very high dynamic range with prodigious input and output signal headroom.
Signal path also delivers high bandwidth, low noise, modest local negative feedback and low distortion, and is voiced for best musical performance.
Radio-Frequency based remote command of the silicon-free high-quality motorised volume attenuator set, for infinitely resolvable control of listening levels. No need to "point" the remote in any direction. Now the Shrimp's attenuator set can be controlled from another nearby room, through walls, floors and doors, and through opaque equipment closet or cabinet doors too!
Dedicated White Follower stage using the 5670 dual triodes effortlessly drives all passive interstage circuits; volume, balance and output stages receive crisp instruction from the Follower regardless of control settings.
Generous energy storage via large power supply capacitors for more impact in the bass.
No global feedback makes the Shrimp very fast sounding.
Also can safely packing and shipping around Australia by buyer cost.
- Date Listed:04/12/2019
- Last Edited:04/12/2019
- Condition:Used
Similar Ads
Marantz 3800 preamplifier
$720
$720Thornbury
Preamplifier
$20
$20Kingsville
Plinius Pre-amplifier M16 remote.
$250
$250Lynbrook
Pro-Ject Audio Systems - Phono E Box Preamplifier
$89
$89Frankston
Pioneer stereo Remote control
$5
$5Tarneit
Niles SSVC Volume Speaker Control unit
$200Negotiable
$200 NegotiableBrighton East
Sony car stereo system with the remote control
$40
$40Cranbourne
Vivid stereo system ( no speakers no remote)
$10
$10Kew East
GA Project - Vintage Pre-amplifier PRE-73
$450Negotiable
$450 NegotiableBlackburn
Leben Phono Pre-Amplifier RS-30EQ
$2,000
$2,000Melbourne CBD
Yaqin MS-12B MM High End Tube Phono Pre-Amplifier / RIAA for Turntable
$369Negotiable
$369 NegotiableDoncaster East
Bathroom Vanity Cabinet Basin Sink Storage Unit Angle Corner 600*800
$149Negotiable
$149 NegotiableBulleen
GLASS SHOWER SCREEN CUBICLE BATHTUB JETS MIXER LCD CONTROLLER
$399Negotiable
$399 NegotiableBulleen
Similar Searches
You don't have any recently viewed items
Any items you have viewed recently will be displayed here