0 Results: New & Used in Engine, Engine Parts & Transmission in Hallidays Point 2430, NSW

✅ 22HP Single Cylinder Diesel Engine ✅ Hopper (Evaporative) Cooling ✅ Brand New ✅ Electric Start ✅ Great for generator, crawler, small tractor etc.

Suits 4 rib belt ,was on grand Vitara wrong alternator mine carries a 5 rib belt It maybe suit a 1.6 ltr Mitsubishi or Vitara a 4 rib serpentine belt

Auto plus transfer to suit 09-15 Toyota 150 prado turbo diesel 190000km

Brand new radiator, been sitting in my shed too long. Automatic transmission model but should fit manual too .

This stepper motor suits the Range Rover classic and Land Rover Discovery 1 3.9L V8 engines. Was removed from a fully working vehicle, written off due to accident damage.

Datsun 1500 Carburettor Pick up Taree or Newcastle

This Motor came from my ZG222 ride on, it did an hours work after it was last serviced, before I decided to install a new motor. It works fine, but wasn’t performing up to expectations. Price reflects recuperation of cost of last service

Ford px2 ranger 6 speed automatic transmission and transfer case (no torque converter) 120xxxks on transmission when remove . In good working order when removed . $2500ono located tuncurry nsw 2428 contact Jason on

I have recently upgraded the turbo internals and manifold of an Audi Ai diesel 1.6 (*****2016), which can also fit a VW Polo 1.6 turbo diesel. I have attached the receipt for the work done on the turbo. As I have replaced it with a larger turbo, I no longer need this setup. If you have any questions, please feel free to contact me, Graham, on . The asking price is $350 or the nearest offer.

This manual gearbox bell housing, input shaft, retaining plate and clutch fork are from a 1998 Landrover Discovery One V8 R380 gearbox. Part numbers are: bell housing and retaining plate are respectively; HRC2642 and HRC 2438. All appear to be in good condition with minimal wear evident on the input shaft splines and bearing and seal surfaces. It would also suit a V8 Range Rover classic with R380 gearbox. The height of the bell housing (face to face) is 275mm. FREE if picked up from Forster NSW