2 Results: New & Used in Engine, Engine Parts & Transmission in Logan Village 4207, QLD

Factory cooler lines to suit 6 cylinder radiator to C4 transmission, removed from an XB falcon 250, the lines are in good straight condition, threads are good and have been in dry storage, local pick up or can freight. Freight charges range between $45 to $85 depending on buyers postcode.

Dipstick and housing sold together. Housing length 360mm end to end, dipstick length from top seal to bottom end 490mm, no cracks in yellow handle, the tube and dipstick are in original shape and top seal seats tight in the tube housing.

Unused multi pupose automotive 12 volt electric fan. Mounts to the front of the radiator or the air conditioner condenser. The fan diametre is 270mm and the depth of the fan assembly 65mm. The mounting holes are 140mm centre to centre and the width of the frame mounts are 160mm. The mounting kit has 40mm long retaining bolts, 12v/20 amp relay, a fuse link and wiring loome.

Six cylinder, Borg Warner cooler lines, removed from an XF falcon, one rear connector hex head has some wear as usual (8th photo), all four threads are good, there is two c clip retainers fitted on the lines, both lines are in straight condition, and have been in dry storage.

6 cyl XL Ford motor with 2 speed automatic GC see running before removed pick up only Chambers Flat

Factory Ford flywheel from a 98 model, 2.6LT, 4 cylinder petrol, 5spd, 2WD, good ring gear and threads, has been machined ready for use. The ring gear is 300mm diametre with 116 teeth and the flywheel is 28mm thick. Local pick up or can freight, freight can range from $26 to around $60, depending on post code.

202 engine turns over I have had it running Have no use for it as only wanted shell it is sitting in chassis take the lot Two guards in pic included rusty rear springs and tow-bar As is no time wasters I will Only answer phone calls no email

Used K&N air filter was on a Mercedes A45 w176. Will fit cla45 and gla45 as they share the same engine.

Works great only hiring it out because I don't use it much . $100 deposit and $50 pick up Friday drop off Monday

Have a LS6 valley plate for sale...this is the upgraded version,with the PCV system attached...which is alot better then the previous LS1/LS2 etc... although it will fit these models...and makes the plumbing a lot nicer and tidier.....