1 Results: New & Used in Engine, Engine Parts & Transmission in Munruben 4125, QLD

For sale is my spare 4l65e gearbox from a cross-8 awd crewman was recently freshened up before I bought it I kept running gear an scrapped the rest. The gearbox is no need any more as I'm using a th400 nothing wrong with it convertor was also freshened up. I have the rear section to make it 2wd to suit any Ls model car instead of the awd set up just missing the rear 4l60e shaft to convert it over to 2wd. It's a strong box for a cammed Ls without spending money to get it to hold 4l65e's are slig

Holden commodore vt vx l67 s pac rear door manual window winder.

Low klms good running condition 4g63t that came out of a auto rvr. Will fit into early evo/gsr Complete long block

BOSCH STARTER MOTOR 6 CYL FITS RED BLUE BLACK ENGINES RECONDITIONED BY QUALIFIED AUTO ELECTRICIAN WILL POST AUSTRALIA WIDE AT BUYERS COST ANY QUESTIONS RING BILL

ZD Fairlane Parts Original 351W Air Cleaner Snorkel to suit ZD Fairlane or XW GT Automatic Still in original paint. $200 ZD Fairlane front windscreen pillar chrome trim $80 ZD Fairlane rear boot lid trim $100 These parts are in good condition as they have been dry stored for well over 30 yrs.

Ford Landau 4 Barrel Air CLeaner Air cleaner base and lid only, No snorkel Been sitting on a shelf in my shed for over 35 years Will also suit XA XB XC and GT Just needs a new coat of paint. Lid is factory Ford chromed as were fitted to the Landau's and LTD's Pickup only

Factory cooler lines to suit 6 cylinder radiator to C4 transmission, removed from an XB falcon 250, the lines are in good straight condition, threads are good and have been in dry storage, local pick up or can freight. Freight charges range between $45 to $85 depending on buyers postcode.

Dipstick and housing sold together. Housing length 360mm end to end, dipstick length from top seal to bottom end 490mm, no cracks in yellow handle, the tube and dipstick are in original shape and top seal seats tight in the tube housing.

Unused multi pupose automotive 12 volt electric fan. Mounts to the front of the radiator or the air conditioner condenser. The fan diametre is 270mm and the depth of the fan assembly 65mm. The mounting holes are 140mm centre to centre and the width of the frame mounts are 160mm. The mounting kit has 40mm long retaining bolts, 12v/20 amp relay, a fuse link and wiring loome.

Six cylinder, Borg Warner cooler lines, removed from an XF falcon, one rear connector hex head has some wear as usual (8th photo), all four threads are good, there is two c clip retainers fitted on the lines, both lines are in straight condition, and have been in dry storage.