0 Results: New & Used in Truck Parts in Wynnum 4178, QLD

Still available if you can see this. Pick up from Capalaba 8am to 3.30pm weekdays or 8 to 10.30am Sat Need rear marker lights for your project vehicle? I bought lights in bulk for some jobs and have more than I need. These are 4 LED multi voltage in RED Used to mark rear extremities dimensions 57 x 34 x 18mm with 120mm flyleads 10 to 32V Brand new in packets about 20 left $4 each CASH on collection NO cards, payID or postage

IN GOOD CONDITION. 460cm H.

Wrapped in news paper from 1976 so hubcaps are at least that old and in almost mint condition 4x10 1/8inch and 2x 9 1/8inch inside lip diameter

Mack CH Cab Generally straight but needs a tidy up. Was mounted to a R chassis (CHR). Rust spot on back corner and has dints in roof from strap lifting (all repairable). A number of cab interior parts missing (including door internals). Trident Bonnet in the photos is not included (but is available). Sleeper in photos is sold. Price is negotiable for prompt collection. All Sold AS IS

Heavy duty 5 TONNE rachet straps . Consists of 2 units ( 2 strap lengths and 2 rachets ) . Made by Ancra Australia . Pickup from Morningside 4170 or I may be able to assist with delivery . For details - Jeff Simpson $50 for both .

A handy compact unit from the team behind Rhino vehicle alarms the VSPOWCONVERTER2 is designed to provide a clean steady source of 12V power (at up to 10 amps) from a DC source ranging from 18V through to 32V. Perfect for running 12V devices in a 24V truck or bus without creating an uneven load on the vehicle batteries, or running 12V devices from an installation that only has 18V, 24V, or 32V infrastructure. The unit is compact, and highly efficient (94%). Instructions are included with

These 7 inch / 178mm sealed beam headlights (24 volt) are fully complaint with all Australian standards, and the correct lens for drive-on-the-left countries like us. They have a 55W low beam filament, and a 75W high beam filament. They will replace OEM sealed beam units, and older style units that were fitted with a standard globe.

These 24V Jaylec 165mm x 100mm (6.5 inch by 4 inch using the USA standard) sealed beam headlight units are designed for RHD countries like ours and meet all relevant Australian Standards. This is the "2 pin" version designed for high beam operation, rated at 55 watts. The units are a direct plug in replacement for OEM equipment. (Until stocks are exhausted we should also have available the matching "3 pin" low beam / high beam units. Most rigs use 2 hi/lo units and 2 hi only unit

These 24V Jaylec 165mm x 100mm (6.5 inch by 4 inch using the USA standard) sealed beam headlight units are designed for RHD countries like ours and meet all relevant Australian Standards. This is the "3 pin" version designed for high and low beam operation, with 50 watts low beam, and 65 watts high beam. The units are a direct plug in replacement for OEM equipment. (Until stocks are exhausted we should also have available the matching "2 pin" high beam only units. Most rigs use 2 hi/lo un

These 5.75 inch / 146mm sealed beam headlights (24 volt) are fully complaint with all Australian standards, and the correct lens for drive-on-the-left countries like us. They are the two pin 55W high beam unit. They will replace OEM sealed beam units, and older style units that were fitted with a standard globe.