Keeping our community safeCOVID-19 Safety Precautions

Search alert

Get notified when new items are posted

Filter & Refine

  • ls1
Petrol - Leaded
ls1Sydney RegionPetrol - LeadedClear all

We found 4 additional ads in surrounding suburbs.

1969 Chevrolet Camaro LS1

  • 3500 km
  • Coupe (2 door)
  • Manual

1969 Chevrolet Camaro Hugger Orange with Black Rally Stripes Ls swapped to look like the factory 350 chev that was common in these cars. This Camaro is a factory V8 car. Behind the Ls1 is the factory TH350 and factory 12 bolt rear end Rally Wheels from Rev Wheels 17x8 fronts and 17x9 rears with 5.5 backspacing running on Falken Azenais K453 tyres Fronts are 245x45R17 and the rears are 275x40R17. Factory boosted disc brake front end with factory drums on the rear. Car is lowered approximately 2

Cambewarra Village, NSW


1971 holden hg kingswood

  • 15500 km
  • Sedan
  • Manual
  • 6 cyl

Hk ht hg kingswood premier 1971 Hg kingswood 186 3 speed manual Runs drives and stops as it should (no rego) (no rwc) Plates on the car are the original plates from new Have a lot of paperwork, from new purchase through to the only other two owners (Has completed afew 3-6 hour drives within the last 6 months) The car is duel fuel but hasn’t been ran on gas in a long time and the tank is out of date Has afew rust bubbles in 2 of the doors, slight bubbling on one of the front lower gaurds and

Thomastown, VIC


Holden vk commodore built ls1 T400

  • 300000 km
  • Wagon
  • Auto
  • 6 cyl

(Selling complete) 1984 vk exec. built ls1 on e85 vcm13 super victor manifold. only second hand parts was the crank and block everything else was new. manulized t400 with 4500 tce convertor 1 peace tail shaft vl turbo diff with 3.9s and a mini spool. full fuel system with 2 pumps and a surge tank 40l cell Made 303rwkw yellow top battery in the boot Alternator is a couple of years old Has under drive balancer Gauges are. Tacho. oil pressure. water temp.trans temp Has vt front brakes. It’s on vn

Carrum Downs, VIC


Mazda rx7 1984 series 3 drag race drift shell

  • 0 km
  • Coupe (2 door)
  • Manual
  • 2 cyl

Hi all, I have here a dedicated race / drag car / drift or doner shell. Its a roller mazda s3 rx7, completely stripped out (No interior) custom wiring loom and relay/fuse panel and switches ect, small battery in cabin, no dash but has autometer gauges, racing seat and harness, hydraulic handbrake, 9 inch diff with billet axles, locker ect. Lexen glass except for windscreen, lots of weight taken out of the car so very light. No intercooler holes cut in engine bay, could be put back on the road b

Kurunjang, VIC


Search alert

Get notified when new items are posted