1 Results: head gasket in Northam Region, WA

I am wrecking an almost complete 2012 XLT 3.2T 4WD ranger. the majority of the car has been stripped already as I am using the cab shell for another project. The engine looks to have been overheated with coolant coming out the head gasket. Will sell complete with turbo etc $400 I was told the gearbox was also a bit rough downshifting from 4th to 3rd. gearbox only, no transfer case $200 wheels $150 No longer available- tray, headlights, passenger side doors, fenders, driver's side door, fron

• 4029 hr

4500MM Max lift height 4.5 ton lift side-shift Armrest controls Two-pedal drive control Year: 2006 Chassis # H2X394T00016 Showing: 4,029.2 hrs VIN: H2X394T00016 Plus GST The head gasket needs doing.

Bought it to do my 5L motor up ended up not bothering cause bore was rooted But it’s got the thickest head gasket to suit a little boost or a standard motor No bottom end bearings Paid a fair bit more Text message only Cheers

Clubman bonnet - $250 Early Moke bonnet - $250 boot panels - $100ea Sedan roof - has had the drip rail returns cut off but would be perfect for filling in a sunroof - $250 16x7" 4x100PCD FWD offset, Raix wheels $600/set of four 17x7" BMW Mini wheels $250/set of four 1098 motor, 30"over with new head gasket following head off inspection - $1500 ECAM head with partial valvetrain - $100 Inspection and pick up in Bellevue. Calls preferred, email/PM if you're not near a phone - NO SMS

Chevy 350 engine. 40 thou pistons. Only 2 thou of bore wear. Flat tappet cam. Vortec heads not much guide wear but exhaust seats a little wide. All accessories shown in photos can be with the engine so a conversion to Holden can be done easily. May run as is with a good clean up but would be better with a hone and new rings and gaskets. DL 10826. Casting number is 3970010 350

Reconditioned cylinder head pair for injected 5.0l holden commodore vn/vs preasure tested bead blasted valves and seats cut head gasket surface machined ,assembled new valve seals

Selling various engine parts to suit a 2.5 ltr diesel YD25 engine for a D22. (All operational prior to engine doing a big end bearing) *Brand new Single notch head gasket (*was installed breifly during rebuild) $35 Valve cover gasket NEW $25 Thermostat Housing $25 Brand new set of valve stem seals $25 Miscellanious pipes, oil pressure sender unit, oil level sensor, Rear main seal housing etc Text or message please.