0 Results: New & Used in Farming Equipment in Maryborough 3465, VIC

Auramo rotating grab, Would adapt to excavator

Has been sitting for some time, Track chains & sprockets are worn out, Motor starts and runs good but leaking diesel into water, Reduced Price. Please call Jeffrey $26500 GST

18 Run coil tynes seeder with Baker boots And disc coulters, New cups and hoses, In good condition,

Honda hydraulic power pack, fitted with hydraulic brakes and tail lights

• 0 hr

Silvan Boom spray, 3PL, PTO Drive, 600 Litre, 5.8 meter Boom, Call or ****2387

Connor Shea 30 disc offset Good condition

Front end loader on Fiat 411R. Strong loader. Working fine. Front axle strengthened. Power steering. Rear wheel load. 4 cyl. diesel. Selling reluctantly but due to illness not able to use and family members not experienced. $5995.00 Old Ferguson Rake believed to be the first model sold by Ferguson. Model D-EE20 Sn 1342 Made in England. Original label. Was used and working well until an arm fell of as nut fell of in one end. Bearing holder/bolt has to be replaced/remade. New no longer available

Steffen Systems Tenpack Accumulator Model 950 Good working condition Comes with tow bar to suit New Holland Baler, Hydraulic lines and wiring through to tractor. Always shedded Used this week Message me for a video of it working Selling due to upgrade. Located Baringhup Vic Ph Doug $12K GST

MATO profi 19 belt vice -x3 MATO hand punchs & pneumatic air punch -x6 boxes of MATO lace clips -belt skiver -standard vice -Clipper belt vice, x2 sizes -x2 boxes of Clipper lace clips -x3 full belts & off cuts Worth in excess of $7500, sold as a lot. would be great for anyone wanting to start working with draper, conveyer or baler belts. Has barely done any work. Asking $3000

Hinomoto E2304 tractor wanted for parts trying to save my one from scrap. Not required to be in working order There are other models with interchangeable parts I would consider This 3 cylinder diesel 4x4 also has 2 wheel drive options for most of the parts wanted Average weight of about one ton I will pay approximately twice the amount that scrap dealers will with bouns amount $ for good Tyers on it Cash paid on pick up only