0 Results: New & Used in Truck Parts in Pinkenba 4008, QLD

Truck Air-conditioning Unit - Viesa Truck Air-conditioning, - Suit truck, tractor, header etc, - Good Original Order, - As New! - Ready to Install. PLEASE EMAIL: OR CALL: .

Volvo fm 2006 Intercooler repaired and pressure tested $1000 Cab ECU $1000 Complete disc brake front axle hub to hub $1100 Front springs $600 for the pair Radiator $700 Tail shaft $500 Frups bar no damage $400 Air tanks $100 each Battery tray $200 Lots of parts phone or message for details check out my other listings for more parts Truck is located on the north side of Brisbane

A handy compact unit from the team behind Rhino vehicle alarms the VSPOWCONVERTER2 is designed to provide a clean steady source of 12V power (at up to 10 amps) from a DC source ranging from 18V through to 32V. Perfect for running 12V devices in a 24V truck or bus without creating an uneven load on the vehicle batteries, or running 12V devices from an installation that only has 18V, 24V, or 32V infrastructure. The unit is compact, and highly efficient (94%). Instructions are included with

These 7 inch / 178mm sealed beam headlights (24 volt) are fully complaint with all Australian standards, and the correct lens for drive-on-the-left countries like us. They have a 55W low beam filament, and a 75W high beam filament. They will replace OEM sealed beam units, and older style units that were fitted with a standard globe.

These 24V Jaylec 165mm x 100mm (6.5 inch by 4 inch using the USA standard) sealed beam headlight units are designed for RHD countries like ours and meet all relevant Australian Standards. This is the "2 pin" version designed for high beam operation, rated at 55 watts. The units are a direct plug in replacement for OEM equipment. (Until stocks are exhausted we should also have available the matching "3 pin" low beam / high beam units. Most rigs use 2 hi/lo units and 2 hi only unit

These 24V Jaylec 165mm x 100mm (6.5 inch by 4 inch using the USA standard) sealed beam headlight units are designed for RHD countries like ours and meet all relevant Australian Standards. This is the "3 pin" version designed for high and low beam operation, with 50 watts low beam, and 65 watts high beam. The units are a direct plug in replacement for OEM equipment. (Until stocks are exhausted we should also have available the matching "2 pin" high beam only units. Most rigs use 2 hi/lo un

These 5.75 inch / 146mm sealed beam headlights (24 volt) are fully complaint with all Australian standards, and the correct lens for drive-on-the-left countries like us. They are the two pin 55W high beam unit. They will replace OEM sealed beam units, and older style units that were fitted with a standard globe.

New and never fitted, ex ADF surplus part

All three brand new and never fitted

Ex ADF, brand new and never fitted