8 Results: New & Used in Truck Parts in Salisbury 4107, QLD

I have a running take out QSM11 Cummins industrial engine for sale. This engine has had a bearing roll, front & rear seal's replaced, full service and valve set. The engine has been dyno tuned and full report is available with the engine. It performed as per factory specification, 400HP @ 2100RPM. It is sold as an outright buy. This engine is also subject to GST when sold.

This is a FD/FG hino drivers seat without suspension in goodbcondition location Salisbury Brisbane

Currently have 2 x N14E Cummins blocks for sale. They have been machined, tunnel & faced, STD LPF for both, reports on request. No cam bearings fitted. These are Remanufactured bare blocks only.

Currently have a standard / standard 12v92 crankshaft for sale. The crank has been checked, tested and polished by a local engineering shop. Report available on request. The crankshaft will be sold with genuine mains, bigends and thrust washers. The crankshaft is currently split and can be sold in halves if required. Location is Salisbury, Brisbane.

I have a remanufactured Cummins 6CT/CTA block available. We have had top deck machined, counter bores, main tunnel etc all been done. Block will come with report from engineering shop, this block is ready for final clean and ready to use. I can ship anywhere in Australia via TNT for a cost. Rebuild kits are also available. The ESN on the block is hard to read, but option tag was*****4107 and CPL was 1845. Some parts are available as well. Price is subject to GST when sold.

I have a checked and polished standard / standard crankshaft. It will also come with a full set of GENUINE main bearings, con rod bearings and standard thrust washers. Price quoted is plus GST. Available ex Brisbane

Current stock of 5149878 brand new "GENUINE" 8V92 cylinder heads direct from USA. These heads are bare, but come with plug kits and bridge posts. We can assemble if required with new parts but these are aftermarket. (valve kits, valve springs, valve spring seats & caps). This is at an extra cost. (TBA) VRS top kits are also available "GENUINE" from $125.00 plus gst Price is plus gst on sale and sold outright

Currently wrecking 2 x 6V53TI marine engine's. Rated at 400HP. Cylinder heads have been removed and remanufactured for stock purposes. All other parts are available. All parts if required tanked, cleaned and checked. Price is per each engine and plus GST if applicable. Engines can be remanufactured and pricing on request. Blocks, crankshaft and camshafts all CAN be machined ready to go. POA.