0 Results: New & Used in Trucks in Seven Hills 4170, QLD

2 off LED Stop/Rear Position/Rear Direction Indicator/Reversing Lamp with Retro Reflector as NEW NEVER USED 2 off left and right $100.00 FOR THE TWO

• 280000 km
• 4x2
• 3500 kg(GVM)

2008 Isuzu NPR 200 From $19950 Automatic Car license approved Fully serviced with receipts Hydraulic tail gate lift also recently serviced Rwc & rego Cold air conditioning 3 seats

Truck Air-conditioning Unit - Viesa Truck Air-conditioning, - Suit truck, tractor, header etc, - Good Original Order, - As New! - Ready to Install. PLEASE EMAIL: OR CALL: .

A handy compact unit from the team behind Rhino vehicle alarms the VSPOWCONVERTER2 is designed to provide a clean steady source of 12V power (at up to 10 amps) from a DC source ranging from 18V through to 32V. Perfect for running 12V devices in a 24V truck or bus without creating an uneven load on the vehicle batteries, or running 12V devices from an installation that only has 18V, 24V, or 32V infrastructure. The unit is compact, and highly efficient (94%). Instructions are included with

These 7 inch / 178mm sealed beam headlights (24 volt) are fully complaint with all Australian standards, and the correct lens for drive-on-the-left countries like us. They have a 55W low beam filament, and a 75W high beam filament. They will replace OEM sealed beam units, and older style units that were fitted with a standard globe.

These 24V Jaylec 165mm x 100mm (6.5 inch by 4 inch using the USA standard) sealed beam headlight units are designed for RHD countries like ours and meet all relevant Australian Standards. This is the "2 pin" version designed for high beam operation, rated at 55 watts. The units are a direct plug in replacement for OEM equipment. (Until stocks are exhausted we should also have available the matching "3 pin" low beam / high beam units. Most rigs use 2 hi/lo units and 2 hi only unit

These 24V Jaylec 165mm x 100mm (6.5 inch by 4 inch using the USA standard) sealed beam headlight units are designed for RHD countries like ours and meet all relevant Australian Standards. This is the "3 pin" version designed for high and low beam operation, with 50 watts low beam, and 65 watts high beam. The units are a direct plug in replacement for OEM equipment. (Until stocks are exhausted we should also have available the matching "2 pin" high beam only units. Most rigs use 2 hi/lo un

These 5.75 inch / 146mm sealed beam headlights (24 volt) are fully complaint with all Australian standards, and the correct lens for drive-on-the-left countries like us. They are the two pin 55W high beam unit. They will replace OEM sealed beam units, and older style units that were fitted with a standard globe.

• 200 hp
• 235000 km
• 4x2

Isuzu FRR 500 with 9m Hiab, tipper body and tool boxes, been used as a service truck predominantly, runs well, good internal and external, rego just paid, multitude of uses, selling due to larger tray required for container, serious buyers please.

Shown here are a pair of our ramps with a huge full size farm quad bike and rider. These ramps weigh more than others due to the thicker gauge alloy used throughout, making them strong enough to easily handle the weight of a farm quad that just barely fits in the back of a ute! Each ramp is rated at 340kg safe load. Size unfolded is: 230cm x 28cm Total weight: 18kg/pr 2 x Security straps provided. Material: Grade 6061 Aluminium Alloy. This alloy has a high tensile strength and low fatigue whi