76 views
Honda Civic EP3 type R Mishimoto silicone radiator hoses K-swap K20K24
$90
for sale Mishimoto black silicone radiator hoses to suit EP3 typeR
This radiator hose kit will also fit onto a K swapped civic EG/EK or DC2 Integra that is running a full size radiator with a k20 or k24 head.
A small section of the bottom hose was trimmed so it could fit my setup. If your running any brand of swivel neck thermostat this is no problem it will fit, with a stock plastic thermostat housing don't think this hose kit will fit.
This won't fit a half size radiator setup.
Comes with hose clamps
$90 for the hoses plus $10 postage Australia wide or pick-up 2260,NSW, Terrigal
This radiator hose kit will also fit onto a K swapped civic EG/EK or DC2 Integra that is running a full size radiator with a k20 or k24 head.
A small section of the bottom hose was trimmed so it could fit my setup. If your running any brand of swivel neck thermostat this is no problem it will fit, with a stock plastic thermostat housing don't think this hose kit will fit.
This won't fit a half size radiator setup.
Comes with hose clamps
$90 for the hoses plus $10 postage Australia wide or pick-up 2260,NSW, Terrigal
- Date Listed:21/03/2024
- Last Edited:02/04/2024
- Condition:Used
- Warranty:No
- Transmission:Other
- UrgentBuilt Barra Atomic Performance 998 - GTA long motorselling my fully sick and fully built barra Atomic Performance 998-GTA spec long motor mods: ACL Competition rod bearings ACL 360degree thrust bearings Atomic FatRods Atomic Stage 4 camshafts Atomic Stage 2 prep crankshaft (mangafluxed and micropolished) Multi-angle valve ported head @ 30. 45. 65 degrees rotating assembly Dynamically balanced engine block bored .5mm over standard engine block torque plated and honed Atomic harmonic balancer - Race series Atomic 12-pt balancer bolt w/ washer At$15,000NegotiableTerrigal, NSWā¢2d
- HONDA EG EK DC2 Front Suspension Sale HARDRACESelling front suspension setup to suit HONDA EG EK DC2 with HARDRACE bushings. I cleaned up all the arms, painted them in VHT epoxy single stage black paint. The bushings were on my car for < than 1 month, they are in near new condition, still got plenty of life in them. HARDRACE hardend rubber front compliance bush - $75 Front shock forks suit EG/DC2 - $75 Front complete lower arms with HARDRACE hardened rubber bush - $300 or the whole lot for $400 Can post australia wide @ buyer's exp$400NegotiableTerrigal, NSWā¢2w
- Hardrace RTA hardened rubber bush Honda EG EK DC2selling my Hardrace rear trailing arm hardened rubber bushes to suit Honda civic Integra EG EK DC2 Bushes are brand new not 1 single km on them, they have been installed into my trailing arms and I've removed them going to a poly bush setup. I can install these with my press into your car or trailing arms if you bring them to me for an extra $50. Can post Australia wide @ buyer's expense or pick-up from Terrigal, NSW, 2260$80Terrigal, NSWā¢3w
You don't have any recently viewed items
Any items you have viewed recently will be displayed here