1 Results: New & Used in Brakes & Suspension in West Gosford 2250, NSW

95% BMW E39 Brake Pads Bought these by mistake so make sure they fit your E39. Postage would be around $20

Complete power steering set up from a 94 Feroza. Looks fine, no leaks. Price is not negotiabl, thank you. Pick up only, from Lisarow NSW.

Tidy, non leaking front diff removed from 94 Feroza. Pick up only, from Lisarow, NSW

Replaced at 2500km, very good condition. Upgraded to H&R very early.

All most new 3in front coils did about 1000ks to soft for my set up .

Toyota 2021 V8 70 Series (Troop Carrier) factory original Shock Absorbers These were on the car for its boat trip from the factory in Japan to ARB where I replaced them with a GVM upgrade They have done somewhere around 17klm in total travel so basically unused as can be seen in the photos

Selling front suspension setup to suit HONDA EG EK DC2 with HARDRACE bushings. I cleaned up all the arms, painted them in VHT epoxy single stage black paint. The bushings were on my car for < than 1 month, they are in near new condition, still got plenty of life in them. HARDRACE hardend rubber front compliance bush - $75 Front shock forks suit EG/DC2 - $75 Front complete lower arms with HARDRACE hardened rubber bush - $300 or the whole lot for $400 Can post australia wide @ buyer's exp

for sale: Carbing front strut brace, Strut bar type I suits Honda EG EK DC2. material: steel colour: powder coated White Bar is in used condition, examine all photos carefully there are some scratches on the finish. The bar itself is still strong and will reduce chassis flex. Can post Australia wide @ buyer's expense or pick-up from Terrigal, NSW, 2260

For sale Carbing rear strut brace, strut bar type I suits Honda EG EK DC2 Material: Steel Color: powder coated White Bar is in used condition, examine all photos carefully there are some scratches on the finish. The bar itself is still strong and will reduce chassis flex. Can post Australia wide @ buyer's expense or pick-up from Terrigal, NSW, 2260

Jdm dc2 98spec type-r 25mm front sway bar for sale Comes with Hardrace endlinks, Hardrace bushing and stock D-bracket. This will fit on any 90's honda EG/EK/DC2 so long as your using an EG/DC front subframe and lower control arms. I painted the bar in 3 stages with some etch primer, blue enamel paint and matte clear. There's a few niks and scratches in the finish its not powdercoat. Can post australia wide @ buyer's expense or pick-up 2260, Terrigal, NSW