4 Results: landcruiser in Horsham Region, VIC

Tekonsha Prodigy P2 electronic brake controller. In good condition with cradle and wiring loom. Was used in 200 series Landcruiser but will suit any make and model... Can post at buyers expense

Genuine Landcruiser V8 Crossover Pipe off VDJ79r, can post at buyers expense...

Will suit Toyota Landcruiser 79 series VDJ 2008- Current. They are a pair and will suit the front end factory replacement up to a 50mm lift. Purchased 2 pair by mistake so have one pair for sale. They are brand new and never fitted. Can post is required.

Nolathane rear Leaf Spring Front Eye Bushing Kit, contains 4 Bushings, 2 Tubes, 4 Washers To suit the following models - TOYOTA LAND CRUISER******2007 - LAND CRUISER 78 SERIES TOYOTA LAND CRUISER******2007 - LAND CRUISER 79 SERIES TOYOTA LAND CRUISER 2007-ON - LAND CRUISER 76, 78 SERIES TOYOTA LAND CRUISER 2007-ON - LAND CRUISER 79 SERIES

Original clutch assembly for a 2020 Toyota landcruiser. Only done 5000km in the vehicle. Has flywheel, thrust bearing, clutch plate and pressure plate. No damage or wear. Replaced with a heavy duty clutch when a power upgrade was installed.

Vacuum brake booster from a Toyota landcruiser, 79 series, 6/2020 It was taken from the landcruiser at 30,000km. As new. This is an original part in excellent condition. Comes with original brake hoses.

Bought to replace the old STD size pistons, upon further inspection of the bores in my motor I've since decided to go all out on a ground up rebuild which in turn requires oversize pistons so these are also surplus to my needs. These are late model, short sleeve pistons with the steel insert in the top ringland to hold all the boost in. Comes with Japanese rings. Cost me 1150 to my door, quite firm on price Will trade for parts for a hj75, white rust free roof panel, rear windows panel,

Brand new, still in the packet, no surface rust just surplus to my needs Tags, hj60 hj61 2h fj60 hj75 12ht turbo landcruiser

New Elsworth Trailing Twin Bale Feeder The 4’ model will feed any 4’ wide bale, 4’ high to 6’ high. The twin bale feeder can feed out silage through to tight oaten rolls. The twin bale feeder has a heavy duty construction from Australian steel. The chassis is made from 125mm x 75mm x 6mm RHS. A flat floor enables tight silage/oaten rolls to easily unroll and start feeding out. The deep 20” chamber prevents rolls from coming out of the feeder when feeding on hilly terrain. Feeder shafts

The Elsworth twin bale feeder comes in two sizes, 4’ and 5’ models. • The 4’ model will feed any 4’ wide bale, 4’ high to 6’ high. • The twin bale feeder can feed out silage through to tight oaten rolls. • The twin bale feeder has a heavy duty construction from Australian steel. • The chassis is made from 125mm x 75mm x 6mm RHS. • A flat floor enables tight silage/oaten rolls to easily unroll and start feeding out. • The deep 20” chamber prevents rolls from coming out of