HUSABERG FS650E 2005 MOTARD
ONE OF THE FASTEST MOTARDS & LEARNER APPROVED BIKES OUT THERE
DOMA TITANIUM EXHAUST SYSTEM
LIGHT WEIGHT AT 109KGS
RECENT REBUILD - HAVE ALL RECEIPTS
I have a 2004 Husaberg Supermoto for sale. It is a 650 and weights just over 100kgs. It is super quick and has been termed a "race bike with indicators and a brake light" in a few reviews I've read. It was in storage for around 3 1/2 years as i am a fifo worker and have spent the last 2 years offsho...re. This is also the reason for it's sale. I will be moving overseas and have no use for the girl.
It is an honest bike and everything except the tail tidy kit i put on it is stock. I put some ...show more
Used Front 21” and Rear 18” wheels for KTM and Husaberg.
Awesome condition – Hardly used - Top of the line brands - Set-up for hard-pack Aussie conditions!
The rear rim is from BEHR – Germany. It is 18” x 2.5 inches. This rim came out standard on the KTM 640 (It has the KTM logo etched into the ...rim). It is very tough and wider than the standard KTM and Husaberg enduro 18” rim (which are 2.15 inches). The added rim width results in a wider contact area for the tyre which is very well suited ...show more
For sale is a 2004 MY05 Husaberg FS650 Supermoto in very good condition.
This bike only has 36 hours of use on it and has only travelled 2254km since new. It is a purebred Supermoto and is virtually a race bike with blinkers.It is increadibly quick off the mark. It is also LAMS approved!
Reg...istration expiring in April 2015.
It has always been serviced as per the schedule and been well looked after.
The bike is the rare 'S' model and as such comes standard with all the bling such ...show more
Up for sale is my husaberg (235 hrs had rebuild about 3 thousand kms ago)has full stainless remnus exhaust motard rims and also dirt rims for the keen bike is currently registered but due to circumstances changing/not riding it must go so make a reasonable offer located townsville message or call 0
For sale is the front end off a 2003 FE650 motard converted Berg. It's been overhauled by Teknik suspension and would go great on any motard.
The rear suspension is also done by Teknik.
The brake caliper is a 4 pot Beringer with some decent pads in it, I've taken it all apart and cleaned it out so i...ts ready to install.
Clutch Holding Tool
Medium carbon steel construction with hardened jaws.
Holds clutch hubs, flywheels, gears, sprockets, etc.
Adjustable and lockable jaws open to 125mm (5 inches).
8mm spanner pins.
Recommended - Square tooth style clutch hubs.
Not Recommende...d - V-groove, half round style clutch hubs, and clutch baskets with reversed inner clutch hubs where the integrated clutch faceplate is facing outward.
This tool works in a ...show more
FOR THOSE OF YOU WHO KNOW WHAT THIS IS,LOOK NO FURTHER!!!! FOR THOSE OF YOU WHO DONT, READ ON..........THESE BIKES ARE QUICKLY BECOMING COLLECTORS ITEMS AND THATS EASY WHEN YOUR THE LIGHTEST MOST POWERFULL BAD BOY ON THE BLOCK.
AT JUST 109KG AND 66HP AND 66NM OF TORQUE IN FACTORY FORM , HYDRO CLUT...CH, ELECTRIC START AND KICKSTART OH AND DID I MENTION 6 SPEED? WHY WOULD ANYONE WANT A DIRTY OLD CR500????
BUT AS WE ALL KNOW THEY ARE COLLECTORS ITEMS NOW, SO ITS NOT HARD TO BELIEVE THESE WILL ...show more