23 Results: outboard forward in New South Wales

• Dealer
• Johnson

Outboard Motors, Used, Second Hand, Serviced, With Warranty. Large Range Available From $395 3.3hp Evinrude $395 6hp Evinrudes Early Models from $495 15hp Johnson Long Shaft $1495 25hp Johnson Long Shaft Tiller steer $1495 25hp Johnson Short Shaft Tiller Steer $1895 30hp Johnson & Evinrude Electric Start Long Shaft from $1495 30hp NEW Zongshen Selva Electric Start Forward Control Long Shaft $1990 40hp Sail (Yamaha Copy ) Electric Long Forward Control, Choice of 2, $2490ea 50hp Evinrude Trim Ti

• Single Hull
• 0 ft
• Yamaha

1998 Yamaha 60 Enduro. Was in a forward steer application. No tiller handle but has bracket fitted to mount a hydraulic ram/cylinder fit forward steer. Full service just carried out. Runs really well goes like a rocket. 70hp manual choke carbs fitted. Boyesen glass reed valves installed. Comes with Solas stainless HR Titan 3 stainless steel prop. Was on haines V133 and top speed 68klms. Have videos of it running recently before removed. Inspections welcome. $3,800 ONO.

• Dealer used

YAMAHA 30HP 2 STROKE FORWARD STEER OUTBOARD ELECTRIC START AND ELECTRIC TILT 2008 MODEL, JUST HAD FULL SERVICE MOTOR IS LONG SHAFT/ 20 INCH LEG FITTING AVAILABLE AT ADDITIONAL COST ONCE BOAT INSPECTED COMES WITH CONTROL BOX AND CABLES MOTOR CAN BE VIEWED FROM 8:30AM - 5PM MON - FRI & 8:30AM - 1PM SAT

• 12 ft

SURGE VIPER 12 PRO fishing kayak. It is 3.7m long & is fitted with an outboard beam. It is complete with a Blackhawk 40lb thrust outboard motor, removable padded seat & transport wheels. It is a quality kayak that is well designed, well made & has stainless steel hardware. The hull is completely watertight & as such it is suitable for offshore fishing. The outboard beam mounts the motor with provision for a trolling rod mount on the opposite side. There are plenty of rod holders & provision for

• 1D

Johnson 175 HP Complete outboard motor ,other than forward control unit Parts only- motor is locked up but may be able to be freed up with some work Gearbox and trim and tilt looks ok Hard to find parts for these now. Secured to pallet.We can load our end with forklift

• Single Hull
• 24 ft
• Triton

This is a unique low budget opportunity to spend some quality time sailing on Sydney Harbour and exploring the beautiful bays and overnight anchorages. The boat is a Triton 24 with a fixed keel and is a well renowned and seaworthy design. The hull was stripped and checked for osmosis in 2018 with no sign of problems, then fully primed. It is moored in a dream location in a quiet and sheltered bay in Middle Harbour with a seven day tender service to deliver you to the boat. The interior is fully

• Single Hull
• 19 ft
• Monterey

2004 Monterey 180E Wake Boat • Bow Rider • Fluidcore Wakeboard Tower • Volvo Penta Motor & Stern Drive • Forward/Neutral/Reverse • Swim Platform/Ladder Won’t last long at this price! As if you do your research this is a $35k-$40k boat on boat sales, It just needs a real good detail & tidy up. Also could do with a new battery & alternator. Other than that this boat is truly a great boat, which will give countless hours of fun on the water. Please note I will also swap it for a JetSki, Skylin

• Yamaha

Yamaha 4 stroke 25 HP High Thrust model. Electric start Power Trim and Tilt. Long Shaft Selling with hydraulic steering ram/pump and long hydraulic hoses. Hour gauge and Forward controls included 863 hours . Has been looked after, leg has never been left in the drink Removed from a 33 ft steel framed Houseboat. Houseboat spent majority of its time in Lake Eildon in Victoria before being transported to NSW,then to my yard for major repairs. The houseboat is coming up for sale soon. Has been sto

• 12 ft

Quintrex 350E Explorer with Yamaha F15 LMHA 4 stroke outboard and Telwater (Quintrex) aluminium trailer. This package was purchased new in October 2023 and all components are still in as new condition. The boat comes with 2 x folding comfort seats mounted on stainless steel swivel clamps, carpeted factory low floor and fuel tank rack, glove box, 2 x rear rod holders, 2 x Railblaza trackmount starports with rod holders, 2 x fixed rod holders on the forward thwart and Yamaha 24 litre fuel tank an

Starts and runs, circulates water fine Strong motor starts with no hassles Only issue is, sometimes it’s a little hard to get into reverse other times it goes straight in Comes with forward controls

• Suzuki

2005 Suzuki 30 hp 2 stroke pre mix outboard Electric start and pull start Manuel tilt Forward controls Fuel tank Runs fine Recent service Slightly negotiable Selling due to upgrade

• Yamaha

40HP 2 stroke Yamaha outboard motor Electric start ,manual tilt. Motor is long shaft & has thermostat & impeller replaced ,&gear oil changed. Motor is in top working condition & comes with forward controls. Can see running on stand. Compression 140 &142

• Single Hull
• Steber

Stebercraft Custom made 22 ft Gentlemans Cruiser Custom Dual axle Launch/Service Trailer. Negotiable over $7000. This is a project boat with deservedly Great Aussie heritage and good bones. Generally, most of all the hard work has been done. She is a solid all over fibreglass hull with a 25mm thick flowcoated hardtop. Has tinted glass with nice s/steel framed glass windows ( not Perspex ). Similar to the Steber Persuaders and a little bit unusual,,so I contacted Alan Steber to find out its orig

For sale Yamaha 100hp 4 stroke Carby model 4 stroke 2001 year model Electric start Electric tilt n trim Currently 25inch leg can be converted to a 20inch Runs great Cools perfect Compression good about 185psi equal Comes with Forward controls , engine harness, 2x throttle and gear cable Unkown hours Installation at extra cost. More than welcome to inspect and do any tests . Item located Yennora NSW

For sale - honda 50hp 4 stroke Carbourater model Enrichment choke system Electric start Electric tilt n trim External trim button 3 blade aluminium propeller Good compression on all cylinders Runs perfect Cools great 20inch leg (long shaft) Carbouaters have been cleaned Comes with forward honda controls and throttle cables 3 cylinder Installation at an extra cost of 700 More than welcome to come and inspect and any tests. Item located Yennora NSW

• Yamaha

Parson 40 hp EFI short leg as New comes with electric trim, tilt electronic gauge and electronic forward controls in shipping crate Ready to go

• 1D

Parson, 40 hp outboard engine as New 3 1/2 hours runtime electric start electric trim, tilt, electronic forward controller I electronic gauge short leg

WATERSNAKE VENOM SXW 65/42 TRANSOM MOUNT OUTBOARD 55219 NEW Watersnake Circuit Breaker 5 Forward & 3 Reverse speeds Telescopic handle Voltage Meter Watersnake Venom SXW electric motors provide saltwater anglers with a versatile range of tiller-steer transom-mount motors that are loaded with clever features. The Venom SXW range comprises five motor designs. All propeller shafts are stainless steel and the props have a weedless design so you can push the boundaries during your next adventure.

• Mercury

MAKE AN OFFER…. Didn’t use this motor for 12 months due to travel, rain, etc. went to start but it had stopped working. Tried to take apart to see if it was an easy fix but stripped some bolts in the process. Have just removed the motor and replaced with a 4 stroke, so it’s removed and ready to go. Comes with 3.3m forward controls. Can’t locate the key so need a new key barrel. Near new prop. Maybe a simple fix if you have the skills or it could be something more sinister. May also be useful

Outboard Remote Control Box 704 Single Right-Hand Console Motor Features & Details Smooth Forward & Reverse: Moving the lever forward from the neutral position can engage a forward gear, and pulling the lever back from neutral engages the reverse gear. The engine will continue to run at idle until the lever is moved about 32°. Then, move the control lever farther to open the throttle, and the engine will begin to accelerate. Durable Trim Harness: The control cable features high-temperature r

• Other

Marine Engine control / Concrete Mixer NB0239-00 control series Available from GENERAL AUTO CABLES NB0239-00 A durable chrome finish control with stainless steel lever arms, suitable for exposed installations. Controls with throttle lever have a twist grip throttle brake to handle larger diesel mechanism throttle/governor loads. Suits inboards with hydraulic gearbox's, stern drives and outboards On handle for gear and the other is throttle Detents for forward/neutral/reverse incorporat