0 Results: New & Used in Engine, Engine Parts & Transmission in Bundaberg East 4670, QLD

This is off a 21 i30 engine 51,000km will fit Veloster from 06/2019-07/2021

2 x Yanmar 6LYM-STE Engines for sale, both engines came out of the vessel at the same time due to one engine suffering an internal failure. Both engines have low operating hours (under 2000 hours) 1 Engine is still in perfect working order. However, the other suffered a parts failure during a voyage, causing damage to the engine block. The engine that has suffered the failure would be good for parts as it is still complete. All heat exchangers on both engines had just been serviced/refurbished.

Genuine Isuzu Egr valve and solenoid fitted to test run an engine and then removed. As new condition. Bought new from Isuzu dealer.

tickford none vct motor and auto gear box negotiable

RTS mini spool for borgwarner 28 spline never been used and have the housing gasket to go with it.

7429477 H D76X CASTING NUMBERS 9 PORT NEW VALVES, SPRINGS AND GUIDES. FULL DIP NEW WELSH PLUGS

Holden Camira J genuine parts catalogue and numbers illustrations . Good exploded views and parts numbers for chasing up bits $45 including postage Australia wide Located in Bundaberg Qld

Genuine Toyota Fan Clutch New Old Stock Part Number 16210-51020 Believe that it will fit all VDJ Engined Vehicles If unsure double check with Toyota Parts and your VIN Have 7 in stock Will express post for additional cost.

This listing is for the complete drive train removed from a 1965 Ford Thames 400e van. It is the same engine that was fitted to the Ford Consul MK2. As can be seen in the photos these units are 100% complete. The package consists of a 1703cc engine, 4 speed all syncro gearbox, original driveshaft and rear axle. I'm also including the complete front suspension setup consisting of all of the suspension and brake components as well as the steering draglinks,and chassis mounts. All of these units

Toyota HiAce A44DL automatic gearbox out of a mid 80s YH series van. Has the bellhousing to fit a 3Y or 4Y engine. Internal condition unknown and comes as shown in the photos. Pickup is in Bundaberg or I can strap it to a pallet if you arrange the transportation.