306 views
100A Solar Charge Controller 12V/24V with LCD display & two USB outlet
$40
This solar charge controller is used to link one, two or three PV solar panels (in parallel) to a battery and a DC load, regulating the voltage, charging the battery from the solar panels, and controlling the discharge of the battery to the load.
This is a brand-NEW Solar Controller, in the box, unused.
Send me a Gumtree message to arrange a time for collection...
The integral LCD display displays status, and allows various default control parameters to be adjusted if necessary, using the menu buttons.
Full 3-stage PWM charge management: constant current, constant voltage and float charging [PWM:Pulse Width Modulated]
Built-in short-circuit protection, open-circuit protection, reverse polarity protection, over-load protection.
Default parameter settings are adjustable via a menu system and the LCD display.
Output Timer function: default is ON 24-hours; or selectable : ON for a period of 1 to 23 hours after sunset; or ON from Dusk to Dawn.
Comes with two USB outlets 5V & 3A(max), suitable for charging phones etc.
It will automatically recognise the battery type connected : 12V or 24V, Lead Acid, Flooded, AGM or Gel battery.
(Not suitable for Li, Ni or other batteries).
100A model: Maximum charge current = 100A
Max PV Voltage = 50V (connect multiple panels in parallel, not in series)
Max PV Power = 1200W for a 12V-battery system (potentially up to 6x 190W panels),
2400W for a 24V-battery system.
Max Load on the Output terminals is 100A, suits DC-lamps, small fridge, etc. If you have a heavier load (>1000W) such as an inverter, you should connect it directly to the battery's terminals, as shown in the connection diagram, otherwise you may burn out the controller. But this side-steps the timing and load control features available on the output terminals...
Note that all the terminals on the controller will only accept 4mm2 cable max. - so the output is likely governed by the cable size - keep your cables short to minimise losses.
Multiple solar panels must be connected IN PARALLEL : plus to plus & - to - , (not in series); you may need T-type connectors for this, to connect - to - .
PRODUCT FEATURES
1. Built-in industrial micro controller
2. Big LCD display shows voltage and status
3. Full 3-stage PWM charge management: constant current, constant voltage and float charging [PWM:Pulse Width Modulated]
4. Built-in short-circuit protection, open-circuit protection, reverse polarity protection, over-load protection.
5. Dual MOSFET reverse current protection, low heat production
6. default parameters settings are adjustable via a menu system and the LCD display.
SYSTEM CONNECTION
1. First connect the battery to the charge controller, plus and minus.
2. Then connect the solar panels to the controller, plus and minus.
3. Finally connect the load to the charge controller, plus and minus.
Observe the reverse order when disconnecting. An improper connection / disconnection sequence can damage the controller!
PARAMETER SETTING
The following are the Default settings when connected to a 12V battery. If connected to a 24V battery system the default parameters are double these values. The default parameters should not need to be changed but can be manually adjusted via the menu system.
Float Charge: 13.7V
Discharge Stop: 10.7V [prevents running the battery flat]
Discharge reconnect: 12.6V
Charge reconnect: 13.0V [battery charges once PV panel output exceeds this value]
Working [ON] time : default : ON 24-hours; selectable : ON for a period of 1 to 23 hours after sunset /or ON Dusk to Dawn.
What this 100A unit is REALLY suitable for is to connect two or three 190W / 250W - 350W panels (e.g. for a caravan roof / camper / shack).
It might seem like the "100A" unit could power a small house with 6 or 8 panels, but NO, not this unit. If that's what you want, you need a much bigger/different unit...
________________________________
This is a brand-NEW Solar Controller, in the box, unused.
Send me a Gumtree message to arrange a time for collection...
The integral LCD display displays status, and allows various default control parameters to be adjusted if necessary, using the menu buttons.
Full 3-stage PWM charge management: constant current, constant voltage and float charging [PWM:Pulse Width Modulated]
Built-in short-circuit protection, open-circuit protection, reverse polarity protection, over-load protection.
Default parameter settings are adjustable via a menu system and the LCD display.
Output Timer function: default is ON 24-hours; or selectable : ON for a period of 1 to 23 hours after sunset; or ON from Dusk to Dawn.
Comes with two USB outlets 5V & 3A(max), suitable for charging phones etc.
It will automatically recognise the battery type connected : 12V or 24V, Lead Acid, Flooded, AGM or Gel battery.
(Not suitable for Li, Ni or other batteries).
100A model: Maximum charge current = 100A
Max PV Voltage = 50V (connect multiple panels in parallel, not in series)
Max PV Power = 1200W for a 12V-battery system (potentially up to 6x 190W panels),
2400W for a 24V-battery system.
Max Load on the Output terminals is 100A, suits DC-lamps, small fridge, etc. If you have a heavier load (>1000W) such as an inverter, you should connect it directly to the battery's terminals, as shown in the connection diagram, otherwise you may burn out the controller. But this side-steps the timing and load control features available on the output terminals...
Note that all the terminals on the controller will only accept 4mm2 cable max. - so the output is likely governed by the cable size - keep your cables short to minimise losses.
Multiple solar panels must be connected IN PARALLEL : plus to plus & - to - , (not in series); you may need T-type connectors for this, to connect - to - .
PRODUCT FEATURES
1. Built-in industrial micro controller
2. Big LCD display shows voltage and status
3. Full 3-stage PWM charge management: constant current, constant voltage and float charging [PWM:Pulse Width Modulated]
4. Built-in short-circuit protection, open-circuit protection, reverse polarity protection, over-load protection.
5. Dual MOSFET reverse current protection, low heat production
6. default parameters settings are adjustable via a menu system and the LCD display.
SYSTEM CONNECTION
1. First connect the battery to the charge controller, plus and minus.
2. Then connect the solar panels to the controller, plus and minus.
3. Finally connect the load to the charge controller, plus and minus.
Observe the reverse order when disconnecting. An improper connection / disconnection sequence can damage the controller!
PARAMETER SETTING
The following are the Default settings when connected to a 12V battery. If connected to a 24V battery system the default parameters are double these values. The default parameters should not need to be changed but can be manually adjusted via the menu system.
Float Charge: 13.7V
Discharge Stop: 10.7V [prevents running the battery flat]
Discharge reconnect: 12.6V
Charge reconnect: 13.0V [battery charges once PV panel output exceeds this value]
Working [ON] time : default : ON 24-hours; selectable : ON for a period of 1 to 23 hours after sunset /or ON Dusk to Dawn.
What this 100A unit is REALLY suitable for is to connect two or three 190W / 250W - 350W panels (e.g. for a caravan roof / camper / shack).
It might seem like the "100A" unit could power a small house with 6 or 8 panels, but NO, not this unit. If that's what you want, you need a much bigger/different unit...
________________________________
- Date Listed:22/07/2023
- Last Edited:22/07/2023
- Condition:New
Similar Ads
- Battery Box 500W Inverter Deep Cycle Battery Portable Caravan CampingThere is nothing worse than needing to be somewhere but your car battery is dead. Or, you need to make a phone call, and your phone isn’t charged. What a nightmare! When you need some emergency power, nothing beats the power of a Battery Box. With 2 12V power sockets, a dual USB socket and two terminal posts, you’re covered for a range of charging modes and purposes. You can charge a full range of devices, from laptops to cameras to fans*. No need to worry about safety either; the box comes wit$181.95Kewdale, WA•1w
- 440 Watt Solar Panel Kit For Caravan, RV, Camper TrailerPower up your caravan, motorhome or camper trailer with this 440 watt solar panel kit. The monocrystalline solar technology ensures optimal performance in all daylight conditions. The kit comes with a 1500 Watt pure sine wave inverter and a quality Victron SmartSolar 100/30 MPPT, (maximum power point tracking ) charge controller for efficient power conversion. This solar panel kit is designed for a 12-volt system configuration and features MC4 connectors for easy installation. With a current ou$1,300Wanneroo, WA•1w
- *BRAND NEW* Victron 12V/5A Blue Smart IP65 Battery ChargerIntroducing the Victron Blue Smart Battery Charger, a powerful 12V 5A charger equipped with cutting-edge features. The Blue Smart IP65 Charger comes with built-in Bluetooth functionality, making it an ideal choice for a variety of applications, from workshops to motor vehicles like classic cars, motorcycles, boats, and camper-vans. Key Features: 🔋Robust Design Resistant to water, dust, and chemicals, ensuring durability in diverse environments. 🔋Smart Charging Algorithm: Utilizes a seven-s$126Welshpool, WA•3w
- Portable solar panel with Charge Controller for campingFolding transportable solar panel in carry bag. Has its own folding legs to support the panels at the ideal angle facing the sun. Rated at 120 watts. Includes Charge Controller mounted with the panels. No load voltage output is around 16V DC as indicated on the multi meter in the photos. Just connect to a 12v battery and this will keep it fully charged.$65NegotiableBeaconsfield, WA•1w
- Automotive power supply ,car phone holder and as you see in photo1-automotive power supply. Recorder,earphone holder solar charge controller USB wifi repeater, phone holder 360,universal remot monocular field vision infinite$600Thornlie, WA•3d
- Camper Van parts, solar panels , lithium battery , draws , 12v FridgeToo replace these new just under $3800 These in use for 12 months One X 12.8V 100Ah lithium battery, $800 new RTM:SB2215 Two X 12V 170W Solar Panel $280 new ea RTM:ZM9065 One X 138L Brass Monkey Slim-Line Double Door Fridge/Freezer $1100 new RTM:GH1662 One X Dual Input 20A DC/DC Multi-Stage Battery Charger to suit Lead and Lithium Style Batteries $269 new RTM: MB3940 One X Solar regulator $80 new One X Powertech DC Control Box for External Battery with Voltage Display $239 new RTM:HB8520$2,200NegotiableScarborough, WA•2w
- 11 kVA 240 volt Trade Spec Petrol GeneratorOur trade specified generator is versatile and durable to keep your tools going. This generator is for you if you need a lightweight power source that is easy to transport and does not cost a fortune. If you need a proper portable tradie generator then this is the real deal! Able's 11kVA petrol generator will keep your mind at ease with industry-leading reliability, over 8 hours of continuous, economical use and a compact, tough form factor. Not content to be a terrific backup at home, this mac$2,890Bentley, WA•249w
- 175w Victron Class A Solar Panel with SmartSolar charge controller175w Victron Mono Solar Panel Glass (1485 x 668 x 30) Victron SmartSolar charge controller MPPT 75 | 10 Bluetooth Selling as I only used it a couple of times and just sits in storage. It great condition, never left outside besides when used camping a couple of times New set up for this would be over $400$300Greenwood, WA•4d
- AGM Deep Cycle Battery 12V 100Ah Marine Power Portable Box Solar WAUp for Sale the AGM Deep Cycle Battery 12V 100Ah Marine Sealed Power Portable Box Solar *** WA STOCK PICKUP/DELIVERY *** *** BRAND NEW SEALED *** Our portable Deep Cycle Battery provides off-the-grid power supply for 4WD vehicles, caravans, campers, trailers, motorhomes, saltwater/marine applications, and all 12V appliances including portable fridges and washers. The 100Ah 12V battery features an incredible cycle life of up to 1400 cycles, making it one of the most enduring in its class. Wha$199Baldivis, WA•33w
- New 415w SunTech Solar PanelsNew 415w SunTech solar panels in store ready to provide solar power to your off-grid project. Whether it's an off-grid workshop, home, shed, shack, 4x4 or Caravan, come on down and visit our showroom and warehouse! Solar Panel Specs: Voc: 37.67 Isc: 13.95 Dimensions: 1722mm x 1134mm x 30mm That's only $313.50 each! These are brand new with MC4 connections, and have a 5 Year in-store Warranty! Posted: 16/03/2024. Pricing valid while stocks last, up to 28 days from date of posting. On request$314Welshpool, WA•6w
- 4-drawer Filing Cabinet, gold colour, Used4-drawer Filing Cabinets, two matching available, price is each. Metalux brand, standard office size 480mm W x 630 D x 1320 H, in reasonable condition - not pristine but working fine, solid construction, with removable file hanger rails, would suit A4 or 'foolscap' size files. No keys & no hanging files included. Please send me a Gumtree message to arrange a time to view or collect.$10Carlisle, WA•4d
- OZtrail sandbags, 1-New, 1-UsedOZtrail Commercial Sand Bag Kit, High capacity reinforced sandbag for securing tents / gazebos, etc., Twin-chamber heavyweight woven polypropylene design holds up to 20kg of sand, with quick-connect webbing straps, heavy-duty handle and steel locking pin for securing bag directly to frame. Zippered openings for easy filling. One sandbag kit completely new & unused with its travel bag: $25 One sandbag kit used once with clean sand, no travel bag: $20 Both would fit together into one travel bag:$20Carlisle, WA•5d
- Circular Saw Blade NEW, Carbide Tipped 165 x 2.3 x 20/16, 24teethCircular Saw Blade NEW, Tungsten-Carbide Tipped teeth, 165mm OD x 2.3mm kerf, 20mm or 16mm bore (adaptor ring), 24teeth, suits wood / MDF etc (not metal). Max 8000RPM. New, unused, in its box. Please send me a Gumtree message to arrange a time to inspect or collect. Sorry no offers.$10Carlisle, WA•12w
You don't have any recently viewed items
Any items you have viewed recently will be displayed here