0 Results: New & Used in Other Audio in Oatlands 7120, TAS

This is a fully restored Dual 1010 from the mid 60s in immaculate condition. Sitting in a re-finished wood veneer plinth, the turntable has been completely dissasemebled, cleaned, re-lubricated and adjusted for correct operation. The 4-pole motor has been serviced and the acrylic lid re-polished. It has full automatic and manual modes with adjustable pitch control across 33, 45 and 77 speeds. Featuring its original high ouput Shure M75-6S cartridge with a new stylus, this turntable both loo

PHONAK ROGER PEN & MY-LINK HEARING AID ACCESSORIES NEVER USED STILL IN THE BOXES OVER $1,500 TO BUY NEW ALSO COMES WITH: SIEMENS BLUETOOTH MINI-TEK SYSTEM WORTH $500 TO BUY NEW WILL SELL ALL OF THE ABOVE FOR $500!!!!

Telinga Modular Professional parabolic field recorder out of Europe with included Clippy EM272 XLR microphones and wind muffles -over AU$1500 worth and only used on one short trip - see my other listed items that compliment this kit. Can post around Oz. See review of this set up here: https://acousticnature.com/journal/telinga-modular-parabolic-microphone-review

Almost brand new, Sound Devices MixPre-3 II 32-Bit 5 Track Field Audio Recorder - used once to test out but won’t be doing the recording had planned to. Post anywhere in Oz. Bargain high quality piece as over $1600 new, which this virtually is!! Can throw in some blank flash cards/plugins too

Turntable AWA Clarion, JVC headshell, Ortofon red cartridge

-Audio Technica ATR2500x-usb microphone. -Cardioid condenser. -Nearly new, not used much. -Suit basic home music recording or podcasts etc. -comes with cords and stands pictured.

New and sealed. Bluetooth speaker from amazon. pickup from mornington

For use in a stereo system. Pair (one for each channel) graphic equalisers, circa 1981. Part of an original DIY ETI system, rack-mounted for 40 years, now decommissioned. Were working at the time the rack was dismantled. Note: sold as is - not tested by me. Good cosmetic condition, very clean internals. The upper unit has an IEC mains AC connection; the lower has it's operating volatge passed down via a 3-pin din connector.

Speaker Stands - home made (not by us) > height 130cm > solid construction (10kg each) > base plate - metal (35cm x 35cm) > top plate - wood (16.5cm x 20cm) > pole - metal ( circumference 32cm) > top and bottom wire holes > speaker screws in base plates > supplied as pair

Works well, bought something with more inputs!