0 Results: New & Used in project boats in Gungahlin Area, ACT

Boat has been sitting around for sometime, overall it is in good condition doesn't leak but needs small repairs, like trim needs fixing up, rewiring also, there's a soft spot underneath that needs patching up, this is a project boat who ever is inclined knows what hes doing with this kind of work can fix it not much involved and just needs to be cleaned, comes with a engine, engine is 55 and is in good condition just needs a service that's what ive been told, comes with the trailer, the lights

• Single Hull
• 23 ft
• Cruiser

23 foot timber cabin cruiser project boat. Boat is fibreglass over planked timber, still structurally solid however needs restoration and set up to suit your engine choice. No engine, I believe this boat originally ran a 6 cylinder Holden engine, however would be a good candidate for a diesel. Boat comes with stainless steel fuel tank, prop shaft and rudder. Trailer not included however transport can be negotiated.

• Single Hull
• 21 ft
• Other

Great project Boat. 21ft fibre class Half cap boat plenty of room for fishing all types, The hull is solid with no known problems and front cap is fully enclosed and can sleep two persons come everything needed to re install, a four cylinder Volvo Penta marine inboard engine for a in and out set up it has the linkage bell housing and come with two outboard legs with props has the tilt and trim lifter to suit, a tone of spare parts, two large stainless steel fuel tanks, motor runs well, only sel

• Single Hull
• 16 ft
• Quintrex

Quintrex runabout for sale, 5hp and fish finder don't come with the sale. Great fishing boat, flat floor and centre console installed, marine carpet. 16 foot tinny, larger than your average 60hp yamaha 3 cylinder oil injected. Bilge pump live bait tank and pump. All wiring re done in the last few months. Perfect for in shore and offshore on the calmer days. Trailer in good condition has rego till December, boat has rego till Feb 25. Am selling because I have another project boat I want to do up

• Single Hull
• 14 ft
• Savage Fibreglass

Fibreglass Savage Avalon *YEAR UNKNOWN* Clean boat. Perfect for a project. Comes with a 1993 50HP Mercury 2 Stroke, not currently installed. Attached to the boat for towing purposes. Motor runs, however needs a good tune up. Comes on a 1987 Jawar Trailer in great condition, rego TJ52ZN. Any questions give me a call.

• Single Hull
• 16 ft
• Savage

Savage Half cabin 4.6m, unfinished project boat. The transom requires work, and the bouyancy seats need fibreglassing. The window rubbers are also perished in the sun and could do with replacement. The motor starts and ran well and had good flow from the telltale. The trailer is in fair to good condition and IS REGISTERED UNTIL 31ST MARCH, it has a new jockey wheel and the electrics don't need work.

• Single Hull
• 8 ft
• Alloy Boats

Project boat aluminium beast10ml bottom 8ml sides need back finished fuel tank put in wich I haven't got have the roof for cab it's sitting in boat as photo shows has to be installed and the floor done have got some aluminium sheets there but due to I'll helf ang just haven't got the time to finish trailer is no good will need tilt tray it's close to 8mtr long 2.4 wide will take twin or single motors would be a 250k boat finished all day long

• Quintrex

Wanted to buy a old school quintrex lazeabout or fishraider in close too original condition have 5k to spend can be a project boat or running and registered can Pm me and detail im located in the illawarra 1hr south of Sydney will travel for the right boat

• Single Hull
• 15 ft
• Seafarer

Seafarer V Sea 15.4ft Caddy Cab. Perfect boat for a project as the trailer and motor are both in good condition. Hull needs work but is structurally sound. The motor is salt water 90Hp Evinrude Etec, the Last of the two-stroke motors with all of the electronics of a 4 stroke. The motor is in good condition and starts the first time, every time. The trailer was replaced and is in good condition but has no rego. Great boat for someone willing to put a little time into it. I have upgraded to 6m Y

• 1D

Never used on project boat.