30 Results: New & Used in project boats in Gungahlin Area, ACT

Boat has been sitting around for sometime, overall it is in good condition doesn't leak but needs small repairs, like trim needs fixing up, rewiring also, there's a soft spot underneath that needs patching up, this is a project boat who ever is inclined knows what hes doing with this kind of work can fix it not much involved and just needs to be cleaned, comes with a engine, engine is 55 and is in good condition just needs a service that's what ive been told, comes with the trailer, the lights

• Single Hull
• 23 ft
• Cruiser

23 foot timber cabin cruiser project boat. Boat is fibreglass over planked timber, still structurally solid however needs restoration and set up to suit your engine choice. No engine, I believe this boat originally ran a 6 cylinder Holden engine, however would be a good candidate for a diesel. Boat comes with stainless steel fuel tank, prop shaft and rudder. Trailer not included however transport can be negotiated.

• Single Hull
• 8 ft
• Alloy Boats

Project boat aluminium beast10ml bottom 8ml sides need back finished fuel tank put in wich I haven't got have the roof for cab it's sitting in boat as photo shows has to be installed and the floor done have got some aluminium sheets there but due to I'll helf ang just haven't got the time to finish trailer is no good will need tilt tray it's close to 8mtr long 2.4 wide will take twin or single motors would be a 250k boat finished all day long

• Single Hull
• Quintrex

Wanted to buy a old school quintrex lazeabout or fishraider in close too original condition have 5k to spend can be a project boat or running and registered can Pm me and detail im located in the illawarra 1hr south of Sydney will travel for the right boat

• Single Hull
• 15 ft
• Seafarer

Seafarer V Sea 15.4ft Caddy Cab. Perfect boat for a project as the trailer and motor are both in good condition. Hull needs work but is structurally sound. The motor is salt water 90Hp Evinrude Etec, the Last of the two-stroke motors with all of the electronics of a 4 stroke. The motor is in good condition and starts the first time, every time. The trailer was replaced and is in good condition but has no rego. Great boat for someone willing to put a little time into it. I have upgraded to 6m Y

• Single Hull
• 4 ft
• Classic

Old school project boat 100ph in back motor need work boat needs good clean up boat and trailer has rego slap another motor on very good boat no time for it needs to go asap 1500 ono No refund Cash on pick up

• 14 ft

Was a project now must go due to moving. Doesn't leak at all, Will need trailer to collect.

• Ski Boat

Very good order, originally purchased for a project. Boat since sold. Over $2000 to replace. Make a reasonable offer........ inboard ski boat, v8 Ford ski boat, Cleveland 351, Alloy Engine mounts and water cooled manifolds. Other parts may be included depending on offers? Other parts include header pipes,foot throttle, water pump. Postage is extra.

• Fibreglass

Unfinished project, complete boat and trailer for sale with working Johnson 50 motor

Half finished project boat. Motor not running haven't gotten around to it just lost interest and time should be a simple fix. 4.5 meters long boat Boat and trailer not registered. Taking up space in the yard need it gone. Open to offers Please do not hesitate to contact

14.9ft Fibreglass boat with trailer Structurally sound No rego or plates Has 2 batteries Will be a project as no engine and wiring is a bit of a mess

• Single Hull
• 16 ft
• Runabout

Half cabin fiberglass boat 5.5m with a 2002 140hp mercury outboard motor with full compressions, both trailer and boat is registered to august next year also comes with a lowrance GPS and fish finder. The boat was a project that I never got to finish welcome to see anytime. Negotiable

• Single Hull
• 19 ft
• Timber

19 fr timber putt putt Needs some repairs and touch ups 18hp Volvo diesel engine needs rebuild Good project $3000 or near offer Feel free to call on

Project boat Needs a fair bit of work Was a great boat till hubby pulled the back end off for repairs but never had time to finish it 250 ono make an offer

• Other

Was bought for a project but never got around to finishing so up for sale Call

• Bullet

Motor kicks over, needs a good clean and would be a good project rig Trailer doesn’t come with any rego, I would recommend a day permit from service nsw.

• 23 ft
• Aluminium

For sale is a 7.2 meter aluminium boat with a Mackay trailer both have long rego project boat

This boat was a restoration project. It has an extensive list of works carried out such as, a new paint job, new motor, and a steering wheel system. Handy features include long range fuel capacity, rear aux engine electric / hydraulic. Offers will be considered.

• Single Hull
• 15 ft
• Custom Line

Custom 1957 4.6m fibreglass boat with a 1961 40hp outboard (short shaft)Johnson running engine (plenty of compression) and a Coaster Trailer with near new tyres & roller's One owner boat (garaged) Unregistered Licenced to seat 6 passengers Needs a polish and tidy up Deseased estate sale comes with boat , trailer & engine paper work.Great project boat $$$$$ must sell $3,000 neg Call

• Single Hull
• 17 ft
• Fibreglass

Located in the Cowra area, good easy project to get back to shipshape. 85hp Evinrude V4, sounder, cb radio, stereo, cover, swabs and seats in ok condition, near new bimini and was serviced and tilt rebuilt before it was last used/parked back in 2020. Tried to kick it over, but no luck, I suspect it's a fuse or some electrical issue based on time sitting. Has a 60 litre stainless fuel tank, and spare plastic one. Boat is unregistered, but happy to register it for sale purposes. Trailer is regist

Speed boat project and trailer comes with a few parts and a v drive gear box or swaps

• Other

reliable pure sineway power from the highest quality inverter charges available with purchase for a project that never completed. I'm selling it at half. the retail price was never used. for further details on the product, please refer to the website link I am working so I would prefer text message if I do not answer your call but will be prompt response needed gone first in best dressed absolute bargain at this price https://www.bme.net.au/shop/inverters-and-chargers/enerdrive-magnasine-pure

• Single Hull
• 1D

5.5 meter open runabout project boat&trailer sold hull no soft spots tilt trailer trailer and boat unregistered trailer tows and handles perfectly contact me any information you need

• 30 ft
• Hartley

Hartley cruiser project. Plywood boat with Dynel fiberglass sheathing. (30ft, 8.1 meters on the water line) Very spacious with 3 meter beam / width. Most of the work is done. Needs a basic fit out and engine. Alson needs an antifoul and repainting on top sides. (Hull paint is in good condition) Transom has been strengthened and Knee braces added for the option of fitting a pod and outboard motor. Small amount of wood rot in flybridge lower edge and inside on the chine. Both are easily accessed