0 Results: New & Used in bedford in Coffs Harbour Region, NSW

• 123456 km

White truck was bought as everything is fairly straight overall and red truck has a reconditioned motor which was going to be transferred into the white body, engine In red truck does run hasn’t been started for a while though. Has bag loader and tipper on the red one. Contact me for more info.

• 1111 km

3 x Bedford Trucks KM 1949, 1950 & 1951 All vehicles are complete but undergoing restoration. Will be able to make 2 going trucks out of the 3. Selling due to too many projects & not enough space. These trucks have been garaged since I have purchased them, therefore have very little rust. Lots of extra bits/parts to be included in the sale as well as a full workshop manual.

1954 TO 1960 BEDFORD motor spares. (as is cond'). taken of J4 wich had thrown a rod back in about 1968. NOT USED Since. $180 (might have cartridge for oil filter[new]) THE LOT...See photo... only

i have a steering box off a bedford truck for sale $350 i also have the steering column and steering wheel separate prices apply

Hi There Vintage truck fuel tank , Little worse for wear but pretty straight, Few small dings Still half full of diesel, May clean to be ok , Hopefully someone can use it Mike

Bedford 10 stud rear axle assembly with diff centre removed from running bus

Bedford 8 stud front axle removed from blp bus new brake linings and wheel bearings

• 175 hp
• 21000 km
• 4x4

Bedford 4x4 Fire Truck (~1979-80) 6.5L 6 Cyl Isuzu Engine 175hp (Reconditioned) OriginaI final Km’s and Hr’s: 21,000kms and 680hrs NEW Rear tyres 90% Front Tyres Approx 3600L Water Tank 8hp firefighter Pump 2x Hose reels Tool cabinets, personnel space Genuine BHP chassis, Cold start first time, runs smooth.

300 cubic inch BEDFORD Petrol Truck Engine ....... purchased from a truck wrecker many years ago for a " J " series Bedford but never fitted . Engine No. 3/J4E/6 181162 . This engine has not been started in a long time but appears to be in good condition ....... we removed the sump and one conrod bearing cap to check the general condition and it looks good . Freight can be arranged to some areas if required ? ...... please send me your postcode if you would like an estimate of the cost .

Pair of old Riveted Centre 20 x 6.00" wide , 8 stud x approximately 285mm P.C.D. Truck Wheels to suit 8.25 or 9.00 x 20 Truck Tyre and probably from a 1950's or early 1960's Truck but NOT Bedford . I also have some other old Truck or Bus wheels available and can freight to many areas if required .