4 Results: New & Used in Engine, Engine Parts & Transmission in Stafford 4053, QLD

if you can read the ad, it is still for sale this is a new oxygen sensor bosch part No ******3156

if you can read the ad, it is still for sale this is a new set of flexible coupling from febi 14979 Mercedes 2104101115 and others

Porshe 986 air mass sensor, New from porshe are $600 odd. Happy to freight around Aust.

VS V8 FUEL TANK STILL UNDER CAR PUMP IS CACTUS $ 350 FIRM TXT OR MESSAGE MIK AFTER 4.30 PM DUE TO WORK THANK YOU

STILL CURRENTLY IN VS STATESMAN 217XXX ON THE CLOCK DUE TO FAULTRY FUEL PUMP CANNOT HEAR RUNNING CONVERSION CONSISTS OF RADIATOR AND SHROUD MOTOR GEARBOX COMPLETE WITH WIRING HARNESS COMPUTER ..GEAR BOX CROSS MEMBER..K FRAME..FULL EXHAUST $ 4000 FIRM TAKE THE WHOLE CAR FOR $5000 MESSAGE OR TXT MIK AFTER 4.30 PM DUE TO WORK THANK YOU

GSP CV for Toyota Hilux N70 Good condition cv, needs 1 x re boot. Only removed as had hoped in boot a year or so ago. Kept as a spare and always intended on getting g the boots done to use full time. Never happened and now having a shed clean out. This was in a 2008 Toyota Hilux dual cab. Should fit any Hilux from******2011/12 I believe. Part numbers on the box and purchased through Bursons. Please feel free to contact them with numbers to confirm fitment. Please contact via txt or message here

Selling radiator and fan setup from a Polaris ranger. These work fine and have no leaks or holes. Inspection welcome but will need to organise a time. Chasing $200 negotiable for full setup in photos. Best method of contact is via messaging here or txt due to work and work hours.

Doing a pre-Christmas/New Year clean out - would like everything gone ASAP. Were left with me - all I know is that they have not been inflated (I had them looked at). Looks like they have been taken from vehicles which may have been written off. All in tact. $200 for the pair ONO (I’ve been told they can cost around $200 each).

Axles for early viscous LSD or ver 3/4 Suretrac LSD. One axle has an extra small spline to drive the LSD diff centre. Newer VLSD do not use these axles (I have a newer VLSD listed which DOES NOT require these axles). Very hard to find. Came in my MY95 WRX. I’ve already sold the diff. One inner boot has split but they are easily replaced ~$30.

Very Good condition, I bought it for my spare car but thought I’d put it up for sale since that build is on pause for now. Fits any R160 diff, keep the craown wheel for 4.44 diff or fit your crown wheel if you a different ratio. Works with standard axles