1 Results: New & Used in Boat Accessories & Parts in Cambridge 7170, TAS

• Custom

Stone Gard made for a stacer 525 3mt long by just over a meter high made by McPherson in Hobart

• Rl

Hauler in as new condition, only used 3 Times. Has relay and switch on housing. Comes with all cabling, switches and brackets Calls or Texts only

• Volvo

Volvo Penta DPH D1 Stainless Steel Duo props. H3 size. good condition, 1 pair including nut & nose cone. $1500. Also extra Front prop. $750. 2 sets of bronze G3 props to fit DPH. Front props have been rehubbed. Set of G props including nose cone, $1200/Set. Other DPH D1 parts including Volvo binnacle, electronics, trim pumps, complete transom units & hydraulics. 1complete outdrive, 1.69:1 ratio, operational when removed, & 1 top box suit spares/rebuild.

• Ultra

Ultra flex single lever controls made in Italy Handle pulls out sideways for throttle only. top mounted Black cable 4150 mm red 3520

• Mercury

2008 Mercury optimax 115hp outboard. 650 hours. Selling due to upgrade.

• Caribbean

Pedestal seat 550 height 375 at base good condition fibreglass plus a seat to put back on

• Mariner

9.9 horse outboard with upgraded carby pushes like a 12 great little motor been in freshwater most its life only been used a handful of times

• Yamaha

Will buy Yamaha 2 stroke 3-70hp outboards for cash $$$

Lowrance hook 5x hdi Good little sounder, comes with power cord and transducer. Works fine, has gps, downscan, sonar, etc. Does not have maps. Screen is blank. Has gps location speed etc Transducer has a couple of scuffs still works

• Yamaha

E.O.I 3.8M BLUEFIN VARMINT with 30hp 2 cylinder Yamaha two stroke engine. Full custom casting deck and floor. Deep cycle marine battery less than 12 months old. Garmin sounder, does really well, custom made minn kota engine mount and extra bracing rib done professionally by Mass Welding. 20 lt fuel tank. Off-road trailer with 31 inch tyres and a rolling spare with bearing. Tows really well. Maintained by myself so no dockets to prove it but spark plugs and impeller done not long ago. Starts wit