13 Results: New & Used in project in Queensland

• Redco

Redco Boat Trailer unregistered. Would be suitable for a project for repair. Be handy if you or someone you know can weld and have time to repair. Does have some rust issues. Would suit 4m Tinny or under. If the ad is up it is available…. As is $400 ono Phone Craig. PH

Doosan marine engine Model LO34TIH 4 cylinder turbocharged intercooled 120HP @ 3000rpm 3.3litre mechanical fuel pump coupled to a 2.06 twin disc DI DMT50 trans never used. Zero hours on engine, zero hours on transmission. Bought for a project that went in a different direction. Comparable new price is about $38,000

• Haines

Haines Speedboat V 17 R Clear Windscreen Brackets Screws See Measurements. Could Fit Project Boat. $ 150 Only Call greg for Pay and Pickup. t y

• Pride

21 foot pride president project boat. Stringers were replaced and then it's just been sitting for years. Trailer is rusty.

• Mustang

It's been sitting in my paddock for 4 years now its time to move it on, make an offer

• Honda

2007 Honda 175hp I brought this motor about 12 months ago for a boat project. I am no longer wanting this motor. Realised it was way too heavy for the boat i was planning to put it on. I’m not sure what is wrong with it apparently the fella before me said it did starts but not 100% sure. I don’t want to spend any money on it. Would be good for wrecking. Or someone that wants to spend some money on getting it going. Selling as is unsure on engine hours I haven’t touched it since I brought it.

• Zodiac

My dad just passed away and this was one of his project boats, the trailer is brand new, boat needs a lot of work. Selling both for 4k Under the tarp has all the boat accessories and seats etc. Boat is 7.30m long. The boat should still hold air, as dad did replace the rubber, but other then that I don’t have any info on the boat. I am aware the boat needs the most work, so I’m basically selling the brand new trailer and the boat is free ☺️

• Absolute

Looking for cheap or free project boat

Ship Mooring. everything but the bouy. was constructed for a project I have been working but have had to pass on. .7 cube. approx 1.6T not 100% sure. comes with 4m x 25mm thick heavy self-coloring chain. to shackle with all fixing gear to a 4 x 16mm light self-coloring chain. have got transport sorted to marina in redland bay. as is where is. inspections welcome but only to serious buyers. can assist in organizing delivery at your cost.

• Cruise Craft

We have a large 6m duel axel boat trailer for Sale. The Boat goes FREE with it. - Trailer is in great working condition - Boat: Cruise Craft 570 Explorer - would be good for a project. Not currently running but has a good base to start with.

• Yamaha

8 hp four stroke Yamaha. Long leg. Suit yacht. Electric start/trim tilt. Was an Auxiliary on powerboat. Very little use. Very good condition. Brought for project, no longer required. I have replaced the entire electric trim tilt unit with a new genuine Yamaha component and had the outboard serviced by Yamaha dealership. Has spare prop. Both new/like new. All controls with motor.

No longer needed in build project, in opened and still in box. RRP over $3500. Sell 1750

Inner diameter 61/2 inch, outer diameter 83/4 inch Depth of hull entry 5.5cm 6 bolt holes 61/2 port hole opening. Have no nuts and bolts for them. Have had for over 30 years new for a project that never happened. Pick up only