1 Results: New & Used in Brakes & Suspension in Albany 6330, WA

Jag XJ6 Front Suspension crossmember, suit Hotrod / Rat rod project. What you see is what you get, came with a project I have since sold.

One only right hand side

4 x hand brake cables off rear drum brake setup. I think they are GMH Holden, possibly EH HD HR HK HT HG HQ , but I can't remember what they came off! Could also be Ford Falcon XR XT XW XY XA XB ,or Chrysler Valiant. The measurements are; Overall cable length approx 835mm, Outer body length seated approx 570mm. I can post to you for $10.

Holden Rodeo brake master cylinder 2006 to 2008 R A Second hand Works fine 3 months warranty

VE brake pads SS will fit SV6

Took of 2021 dual cab landcruiser at 1000kms

Reconditioned power steering rack for t30 xtrail bought this to replace a leaking rack but ended up being a hose not the rack, so never fitted. Grab a bargain, $250

Advanced brake system, Australian made, in perfect working condition comes with complete kit, off 2018 Toyota landcruiser VDJ79 workmate, I reckon it will fit all 70 series, two units available

4" tough dog suspension for gu patrol good condition

I have a set of brake shoes, Part # SB1012 that from research I have done will suit the front or rear of******1964 F250... Front on a******1966 F250 or rear of a 1965 -1966 F350. These shoes a special bond that I purchased in the belief they were suitable for HJ holden Overlander 4x4 with a jeep chassis - Found that the re-enforcement around the hand brake lever locating pin was to thick so had the original shoes rebonded. Email / Text for more information.