1 Results: New & Used in Engine, Engine Parts & Transmission in Brassall 4305, QLD

2010 Proton Satria Neo auto Transmission. 78186Km

2010 Proton Satria Neo 1.6 S4PH engine. 78186Km

Early Holden 6 cylinder air cleaner with raised lettering & origanal decal. Has been in storage for over 30 years Postage will be $20

JUST REMOVED FROM THE BODIES LAST WEEK. NOT SURE OF THE CONDITION . LOCATED IN WARWICK QLD. CAN BE PICKED UP IN WARWICK

DUAL POINT MALLORY IN EXCELLANT CONDITION. COMES WITH A SPARE SET OF POINTS AND ROTOR BUTTON. IT HAS A NEW CAP FITTED. CAN BE PICKED UP IN IPSWICH OR SENT WITH AUST POST AT BUYERS EXPENSE.

I AM HAVING PROBLEMS SENDING REPLY MESSAGES TO PROSPECTIVE BUYERS ON THE INTERNET. THEY ARE NOT GETTING THEM. IF YOU HAVE ANY QUESTIONS RING ME ON OR EMAIL ME ON OR SEND ME YOUR PH NUMBER OR EMAIL ADDRESS. THE PRESSURE PLATE HAS DONE HARDLY ANY WORK AT ALL. CHECK OUT THE CONDITION OF THE FINGERS IN THE PICTURES. THE CLUTCH PLATE NEEDS RELINING. THE INTERMITATE PLATE IS IN GOOD CONDITION BUT THE OUTER RING IS MISSING. LAST ONE OF THESE I BOUGHT FOR A RACE CAR C

THERE IS NO GLASS IN THE FRONT OF THE LENZ. SOME SMALL AMOUNT OF RUST ON THE BASE OF THE LENZ AS PER THE PHOTO. CHROME SURROUND IS IN EXCELLANT CONDITION. ITEM CAN BE PICKED UP IN IPSWICH OR I CAN SEND SEND WITH AUST POST AT BUYERS EXPENSE.

THIS IS A VERY SPECIAL FRONT CHEST FOR THE EUROPA WITH A LOTUS TWIN CAM ENGINE. IT IS IN PERFECT CONDIITION. IT WAS MADE WITH THE WATER OUTLET ON THE FRONT OF THE CHEST NOT THE SIDE LIKE A LOTUS CORTINA. THEY HAD TO DO THAT BECASUE THERE WAS A CHASSIS RAIL NEXT TO THE PUMP. THE THE ONLY WAY YOU COULD GET THE HOSE ON WAS TO CUT THE CHASSIS RAIL. CAN BE PICKED UP IN IPSWICH OR CAN BE SENT WITH AUST POST AT BUYERS EXPENSE.

BRACKET HAS HAD THE HEADS OF THE BOLTS WELDED TO MAKE IT EASIER TO BOLT IN TO THE CAR. THIS BRACKET SUITS THE ORIGINAL GIRLING BRAKE BOOSTER. IN EXCELLANT CONDITION FOR A 50 YEAR OLD PART. CAN BE PICKED UP IN IPSWICH OR SENT WITH AUST POST AT BUYERS EXPENSE.

THIS CROSSMEMBER HAS HAD A RUSTED IN BOLT ON ONE END TO HOLD THE LOWER CONTROL ARM ON. IT HAS BEEN BASHED OUT OF SHAPE TRYING TO GET IT OUT. CHECK THE PICTURE YOU WILL SEE THE ENLARGENDED HOLE AND THE TWISTED FRAME. IT REQUIRES HEATING UP WITH A OXY AND STRAIGHTENING BEFORE YOU CAN USE IT. NORMALLY SELL FOR ABOUT $400 IN GOOD CONDITION. CANBE BE SENT WITH AUST POST OR PAC AND SEND AT BUYERS COST.