1 Results: New & Used in Engine, Engine Parts & Transmission in St Clair 2759, NSW

Chev Camaro / Citation 173, V6 Cam shafts, used 20/30 grind. Pickup from Hassall Grove or can be posted at extra cost. See other listed items

Pick up from Lugarno 2210

Unidentified car parts, apparently related to an intake manifold. Was meant for an older BMW 135 or M3 but was never used. Free to pick up in Coogee. Please nominate an approximate time

from 78 Troopy - replaced with new exhaust sysytem from DPF back, near new stock exhaust - free

AUTOMOTIVE CARBURETTERS WANTED ANY CONDITION ALL TYPES FOR FREE

CAR BATTERIES 12VOLT WANTED FOR FREE ANY MODEL OR BRAND MUST BE ABLE TO HOLD CHARGE IN REASONABLE CONDITION WANTED FOR FREE

This manual gearbox bell housing, input shaft, retaining plate and clutch fork are from a 1998 Landrover Discovery One V8 R380 gearbox. Part numbers are: bell housing and retaining plate are respectively; HRC2642 and HRC 2438. All appear to be in good condition with minimal wear evident on the input shaft splines and bearing and seal surfaces. It would also suit a V8 Range Rover classic with R380 gearbox. The height of the bell housing (face to face) is 275mm. FREE if picked up from Forster NSW

**WANTED GEABOX** Looking for a Nissan Navara 1998 unleaded, 5speed, 2WD Gearbox

Fiat twin cam engine, good for parts only, you may be able to salvage something

302 Cleveland rods x7 FREE ford falcon Fairmont fairlane