8 Results: New & Used in Farming Vehicles & Equipment in Carisbrook 3464, VIC

• 4 hp
• 1234 hr
• 4x2

1980 Massey Ferguson Tractor 135 4 Cylinder Petrol Tractor Mechanically A1 Condition Runs Like a Dream Reliable Tractor No Time Wasters and LowBallers”$5500 Pick Up from Maryborough Victoria

• 238 hr

Kubota backhoe 4wd tracktor ,Deisel,water-cooled,4 cycle-3 cylinders,maximum speed 2800 rpm,cross power 20 hp/2600 rpm,4wd speeds 3F-3r,1PTO,,serial no-52442, engine no-853738-b20-by-52442—or I will swap for gold or older car,hq,hr,xy,xw,xr around the same price as listed

Steffen Systems Tenpack Accumulator Model 950 Good working condition Comes with tow bar to suit New Holland Baler, Hydraulic lines and wiring through to tractor. Always shedded Used this week Message me for a video of it working Selling due to upgrade. Located Baringhup Vic Ph Doug $12K GST

Front end Loader Forks in good condition. Might be able to assist with delivery depending on location.

MATO profi 19 belt vice -x3 MATO hand punchs & pneumatic air punch -x6 boxes of MATO lace clips -belt skiver -standard vice -Clipper belt vice, x2 sizes -x2 boxes of Clipper lace clips -x3 full belts & off cuts Worth in excess of $7500, sold as a lot. would be great for anyone wanting to start working with draper, conveyer or baler belts. Has barely done any work. Asking $3000

Front end loader on Fiat 411R. Strong loader. Working fine. Front axle strengthened. Power steering. Rear wheel load. 4 cyl. diesel. Selling reluctantly but due to illness not able to use and family members not experienced. $5995.00 Old Ferguson Rake believed to be the first model sold by Ferguson. Model D-EE20 Sn 1342 Made in England. Original label. Was used and working well until an arm fell of as nut fell of in one end. Bearing holder/bolt has to be replaced/remade. New no longer available

Garlic harvester, planter and size sorting machine for sale. Located in Lockwood south, Victoria. Overall in VGC. I bought it but my project did not go ahead. Price $10,500

The Elsworth twin bale feeder comes in two sizes, 4’ and 5’ models. • The 4’ model will feed any 4’ wide bale, 4’ high to 6’ high. • The twin bale feeder can feed out silage through to tight oaten rolls. • The twin bale feeder has a heavy duty construction from Australian steel. • The chassis is made from 125mm x 75mm x 6mm RHS. • A flat floor enables tight silage/oaten rolls to easily unroll and start feeding out. • The deep 20” chamber prevents rolls from coming out of

Connor Shea 30 disc offset Good condition

• 10 hr

Rustic garden art and collectibles All must go ,all reasonable offers considered