13 Results: New & Used in project boat in Sorrento 6020, WA

• Single Hull
• 17 ft
• Penguin

Project boat including engine, trailer and accessories - still under rego. **Offers considered** Boat - 5.2m Penguin half cab with dual battery set up. It does have a canopy but this also needs attention. New carpet and reinforced back panel. Engine - 1999, 135hp v6 Mercury Optimax, Bluewater series engine. Can be tested on site. Trailer - requires a fair bit of work including rust treating and replacing roller system Accessories include - life jackets, radio and in date flares. Lowrance hook r

• Single Hull
• 17 ft

Swiftcraft Seagull 5m 2stroke 70hp Evinrude - (i have previous history working on and maintaining marine engines) Boat unrego'd - no issues to get registered. Trailer out of rego and will need attention prior to running over pits (rusted axle and springs) Weapon of a boat, served well for many early morning and late night trips. Done a fair bit of the fit out myself - includes lowrance sounder, lights, rod holders, bait board, full repower of electrics, switchboard etc. Steering needs work. N

• Single Hull
• 7 ft
• Voyager

This was my long term project but due to age and work load boat getting to big to single handle Refitted with 5lt V8 and a bravo leg Trailer brakes just redone 2 x sounders Dual batteries Needs tlc not used for awhile

• 18 ft

Kingcraft circa 1984 18-foot cubby family cabin cruiser. Bimini is almost new. The Johnson 90 needs work, including electrical and head gaskets, motor turns over and was last in the water 2 years ago, then placed in a secure shed. Maybe replace with a newer outboard. The trailer and boat are registered. The hull cruises beautifully. A great little project! A fabulous family boat, Kingcraft.

• Single Hull
• Ski Boat

1970 clinker ski boat,unfinished project has a rebuilt 308 red motor,needs painting,rebuilt water pump,seats have been renewed,have plywood to fix the floor will come with enginestand aswell

• Single Hull
• 20 ft
• Caribbean

Caribbean Commodore 6.1m Hard Top, 150hp, Tandem Trailer, Full Refit EASTER READY!!! Caribbean Commodore 6.1m Hard Top Transom has just been redone Boat has just undergone a full refit/ fresh paint 150 liter inbuilt fuel tank New Fuel level sender and gauge 150hp Evinrude V6 Outboard 242 hours on gauge Hydraulic Steering fitted 8.5” Colour sounder/GPS combo unit New wiring throughout boat New switch panel New 12v sockets New nav lights New anchor light New Bluetooth/Stereo with alpine speaker

• Single Hull
• Chivers

Unfinished project. Boat hull sound, floats needs rebuild. trailer in good condition not licenced. no time wasters, monies is for boat trailer $2500 ono

• Single Hull
• 16 ft
• Voyager

unfinished project 40 hp johnston runs boat and trailer unregistered

• 20 ft
• Chivers

Project boat I have a chivers fibreglass boat that I was restoring but due to moving interstate I have regrettably had to sell. I have purchased a reconditioned mercruser motor from vic and it is ready to install. Trailer has new axels. The boat is registered but the trailer is not. I have spent over 10k on it so far but open to all offers. My loss your gain

• Single Hull
• 16 ft

5-metre fibreglass hull for restoration. Excellent seaworthy design. Exceptionally well built. I'm including a new 200-litre underfloor fuel tank, which cost me $900. It needs a new marine-ply floor but otherwise a straight forward project. It’s on a rough, unlicensed trailer that’s good enough to move the boat around a yard or shed. I’m an experienced boat designer and builder and chose this particular hull for restoration as my own boat. I’ve recently had a couple of major surgeries and I’m n

• 36 ft
• Northshore

this is the last commercial hull that northshore boats built...survey length 12.4mts,4.2fly bridge planning cabin crusier.everything built and approved by dot surveyors to usl code..solid fibreglass hull. divinycell foam frame ,stringers and deck frames making 4 water tight compartments,full f/g rudder with internal s/steel frame. pintle bearing rudder bridge and tiller..2 3/4 prop shaft 2x 1200ali fuel tanks 2x350 fresh water tanks . 1x 250 hdpe gery water tank .1 900l eutectic freezer .deck a

• 24 ft
• Cigarette

24 Foot project Boat. Designed for mid mount V6 3.8 supercharged inboards but have the room to fit what suits. Hull still needs stiffening and more ribs. Rear deck not started. Have 50 mtrs chopped matt and some resin. Complete CAD drawings . Trailer custom built ( not licenced ). Can no longer allocate the time to finish.

• Multi Hull
• Mustang

Mustang boat Yamaha motor and trailer. Both boat and trailer licensed. Boat not used for three years so is a project. Need to clear. $550 for both Jamie