12 Results: New & Used in Motorcycle & Scooter Parts in South Australia

• 500 cc

bobber Bsa b33 500cc 1949 everything rebuilt new Tyers walk in rego

• 650 cc

This is a 2ba high speed steel counter boring tool. After boring the hole (usually in aluminium) with a 2BA clearance drill the counterbore is used to open the hole up deep enough to allow the head of the screw/bolt to be flush with the surface of the metal. Can also be used to clean out holes already counterbored. This item is new and never been used.

• 650 cc

This is the very rare SUPER PRACTIC throttle twist grip of the 50's and 60's. It is in excellent condition with 7/8" hole for 7/8" bars. It has a nipple as shown with securing screw which only requires a bare throttle wire with no attached nipple

• 650 cc

BSA A 10 crankshaft timing gear. Excellent condition with good teeth and ready to fit to your pride and joy. Suits Golden Flash swinging arm bike.

BSA A7 A10 rear mudguard which has had a piece cut off the rear end. A good sheet metal expert could easily fix this. Has a weld repair as in pics'. Very rare oportunity to get a very sought after item. Willing to post if necessary.

BSA A10 or A7 and maybe others, rear mudguard. Used and maybe has holes not needed but all look to be drilled no rust. Very rare item that doesn't come up for sale very often. Grab a bargain while you can, won't stay here long.

BSA 7" front brake plate with shoes in good usable condition.

• 650 cc

I am selling this brand new BSA A10 8" chrome beauty plate that fits to the front wheel hub. Bought it for my Golden Flash, but selling the bike and never fitted. Is in new unused perfect condition.

• 250 cc

NOTE: ROCKERBOX NO LONGER AVAILABLE. Im selling some of my many BSA parts and this is for a C15 BSA cylinder barrel, head.The barrel has a couple of fins broken but an easy fix by a cast iron welder or use the barrel for replacing fins on another barrel also the head has some fins broken but again a competent alloy welder could fix these easily. Needs valves and springs to make this a complete top end for a C15. Normally the head inlet would be 7/8" but this head has an opening of 28mm and has

• 250 cc
• 99999 km

THIS TWIST GRIP HAS BEEN RECHROMED AND UNUSED SINCE. IT IS MISSING THE FRICTION SCREW BUT OTHER THAN THAT IS IN EXCELENT CONDITION. SUITS 7/8 HANDLEBARS.

• 650 cc

Locking filler cap with two keys. brand new never used will fit most older British bikes with twist lock caps

• 350 cc
• 3000 km

This listing is for a BSA B40M front 7" brake plate complete. It fits the B40 Mk I and also many other BSA models including early B31 B32 B33 B34. I purchased this for my B40M MkII but it is incorrect for my model. In good usable condition