7 Results: New & Used in bsa parts in New South Wales

Bsa motor bike oil tank,horn,various gear cogs

• 500 cc
• 1 km

BSA B33 project race bike with Norton front end, I was building this bike with the intention to be a p3 classic racer but after moving interstate 5 years ago I no longer have the help building it I had. most parts are there probably 80-90%. I had a press up crank made with corello rod and wisco 10:1 high top piston which cost $3500 so the bottom end would be bulletproof. I have Norton commando front end with new fork tubes and new brake shoes for the twin leading drum. the project has been sitt

• Learner Approved
• 1234 km

BSA for sale, 1953 model be good for parts or restore

• 250 cc
• 0 km

1965 BSA C15 250cc Completely Refreshed Having as follows New 40tho over piston & rings New clutch plates &bearings New paint, clutch cable, f/ brake cable, f/axle &bearings, handle bar &levers ,speedo drive & speedo&cable, 12v electronic ignition, rewided through out, New badges, chrome muffler, other rechromed parts.

BSA PLUNGER AND SWINGING ARM MODELS STEERING DAMPER PARTS A7 A10 B31 B33 ETC, CAN POST AT YOUR COST $10

Brand new made in India garbage: finish is crap but ok for not a show bike, one hole for speedo odometer winder is split part way though from the factory but if used on the tacho it just needs filling: the other is the opposite, it's not round or large enough (see photos) so no prize for figuring out what to do... no idea why these are sold as pairs. These were used on a lot of models including the X75 Hurricane. Postage $18.

Bsa air filter box genuine new old stock Part number. 42-4583