0 Results: New & Used in Trucks in Seven Hills 4170, QLD

2 off LED Stop/Rear Position/Rear Direction Indicator/Reversing Lamp with Retro Reflector as NEW NEVER USED 2 off left and right $100.00 FOR THE TWO 12 /24 VOLT

Wrapped in news paper from 1976 so hubcaps are at least that old and in almost mint condition 4x10 1/8inch and 2x 9 1/8inch inside lip diameter

GENUINE NEW Mercedes A2128202639 Headlamp LED Intelligent

Mercedes E Class W212 OEM Left Full LED Headlight E350 E550 E6A2128202

• 280000 km
• 4x2
• 3500 kg(GVM)

2008 Isuzu NPR 200 From $19950 Automatic Car license approved Fully serviced with receipts Hydraulic tail gate lift also recently serviced Rwc & rego Cold air conditioning 3 seats

Truck Air-conditioning Unit - Viesa Truck Air-conditioning, - Suit truck, tractor, header etc, - Good Original Order, - As New! - Ready to Install. PLEASE EMAIL: OR CALL: .

A handy compact unit from the team behind Rhino vehicle alarms the VSPOWCONVERTER2 is designed to provide a clean steady source of 12V power (at up to 10 amps) from a DC source ranging from 18V through to 32V. Perfect for running 12V devices in a 24V truck or bus without creating an uneven load on the vehicle batteries, or running 12V devices from an installation that only has 18V, 24V, or 32V infrastructure. The unit is compact, and highly efficient (94%). Instructions are included with

These 7 inch / 178mm sealed beam headlights (24 volt) are fully complaint with all Australian standards, and the correct lens for drive-on-the-left countries like us. They have a 55W low beam filament, and a 75W high beam filament. They will replace OEM sealed beam units, and older style units that were fitted with a standard globe.

These 24V Jaylec 165mm x 100mm (6.5 inch by 4 inch using the USA standard) sealed beam headlight units are designed for RHD countries like ours and meet all relevant Australian Standards. This is the "2 pin" version designed for high beam operation, rated at 55 watts. The units are a direct plug in replacement for OEM equipment. (Until stocks are exhausted we should also have available the matching "3 pin" low beam / high beam units. Most rigs use 2 hi/lo units and 2 hi only unit

These 24V Jaylec 165mm x 100mm (6.5 inch by 4 inch using the USA standard) sealed beam headlight units are designed for RHD countries like ours and meet all relevant Australian Standards. This is the "3 pin" version designed for high and low beam operation, with 50 watts low beam, and 65 watts high beam. The units are a direct plug in replacement for OEM equipment. (Until stocks are exhausted we should also have available the matching "2 pin" high beam only units. Most rigs use 2 hi/lo un